Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
How to make the batteries perform longer
(1)
Recharge the batteries before they become
completely exhausted.
When you feel that the power of the tool
becomes weaker, stop using the tool and
recharge its battery. If you continue to use
the tool and exhaust the electric current,
the battery may be damaged and its life will
become shorter.
(2)
Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately
after use. If such a battery is recharged
immediately after use, its internal chemical
substance will deteriorate, and the battery
life will be shortened. Leave the battery and
recharge it after it has cooled for a while.
CAUTION
●
When the battery charger has been
continuously used, the battery charger will
be heated, thus constituting the cause of
the failures. Once the charging has been
completed, give 15 minutes rest until the
next charging.
●
If the battery is charged while it is heated
because it has been left for a long time
in a location subject to direct sunlight or
because the battery has just been used,
the pilot lamp of the charger lights for
1 second, does not light for 0.5 seconds
(off for 0.5 seconds).
The battery will not be recharged. In such a
case, let the battery cool before charging.
●
When the pilot lamp fl ickers (at 0.2-second
intervals), check for and take out any
foreign objects in the charger's battery
connector. If there are no foreign objects,
it is probable that the battery or charger is
malfunctioning. Take it to your authorized
Service Center.
HOW TO USE
1.
About remaining battery indicator
When the light turns on, the remaining
battery indicator lamp turns on and shows the
remaining battery. When the remaining battery
becomes low, the light briefl y blinks about once
every 3 minutes. (Fig. 9)
14
State of lamp
Battery Remaining Power
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
Remaining battery
indicator lamp
Press the switch
to turn on the
LED light
NOTE
○
When the AC cord is connected, the remaining
battery indicator does not light up.
○
When using a Multi-volt battery, please refer to
the indicator lamp on the battery for the battery
remaining power.
○
Do not give a strong shock to the switch panel
or break it. It may lead to a trouble.
2.
Turning the light on
Press the switch to turn the light on.
Use the adjustment dial that surrounds the
switch to adjust the brightness.
When the brightness reaches the maximum
(10,000 lm) or the minimum (1,000 lm), the light
briefl y blinks twice. (Fig. 10)
Table 5
Over 80%
60%–80%
40%–60%
20%–40%
Less than 20%
Fig. 9
Tabla de contenido
