Bellman & Symfon BE1431 Manual Del Usuario página 55

Advanced testing
Testing the telephone transmitter is easy. First, make sure that the telephone transmit-
ter is installed properly. For instructions, read the section Installation.
Using the test button
Press both test buttons simultaneously.
1 The transmitter's LED lights up to show that a radio signal is being transmitted.
2 The Visit receiver's telephone symbol lights up to show that the signal was received.
If you have customized the signal, it will react accordingly. See tables on page 109-116.
Using a telephone or a connected accessory
Activate the telephone transmitter using the telephone or any of the accessories.
1 The transmitter's LED lights up to show that a radio signal is being transmitted
2 The Visit receiver's telephone symbol lights up to show that the signal was received.
If you have customized the signal, it will react accordingly. See tables on page 109-116.
If it doesn't work as described above, read the section Trouble shooting.
105 Installer's Guide
Default indication and signal
Transmitter indication
When the transmitter is activated, the LED lights up in green. This means that the
batteries are in good condition. Change batteries If the LED blinks in orange.
Receiver signal
When a receiver is activated, it signals with sound, flashes or vibrations.
The default signal pattern is as follows:
Transmitter Receiver signal pattern
Source LED LED
Landline phone
Green, top
Yellow light
Mobile phone sensor Green, top Yellow blinks 2 x ring signal, high
Other accessory Green, bottom Green light
Landline phone Green, top Yellow light
Mobile phone sensor Green, top Yellow light
Other accessory Green, bottom Green light
 868/315 MHz  433 MHz
Sound Vibration Flash
1 x ring signal, low
Medium
Yes
Medium Yes
1 x door chime, low Slow Yes
1 x door chime, high Slow Yes
1 x ring signal, low Medium Yes
1 x door chime, low Slow Yes
Installer's Guide 106