filtreau SLIM Manual página 4

GB FILTREAU UV-C SLIM 40W/80W
WORKING
The Filtreau UV-C Slim ensures crystal-clear water. The sophisticated design and high quality materials produce
high UV-C radiation with a wavelength of precisely 253.7nm. This high level of radiation kills almost all bacteria,
viruses and even fungi, providing clear and clean water. As a result, the level of added chemicals (eg chlorine) can be
reduced by up to 80%, which ensures more natural, healthier water!
The 1.5mm, SS316 housing is polished on the inside to minimize the chance of any dirt sticking to the walls.
Overall, this increases the effectiveness of the UV-C radiation 35%.
Because of the "Slim" design and 5 different in/outlets (even bottom-outlet!), it will ensure you that it can be
installed even in the most narrow places.
SAFETY AND INSTALLATION REQUIREMENTS
• See the Technical Specifications for the required voltage and current.
• The device may only be connected to an electrical installation that meets the legal requirements. A GFCI (30ma)
and earthed sockets are required. If in doubt always use a certified electrician to install.
• The device, the electronics box, the plug and the power cord must be positioned at least 2m from the tank.
• Always keep the plug free from moisture. Ensure that water cannot track down the power cord to the socket.
(See figure 1 for how to loop the power cord).
• Never submerge the device in liquid.
• The device can withstand a maximum pressure of 3 bar.
• The device is only suitable for fresh, not salt, water.
• The device is designed to operate with a water temperature between 0 and 40 degrees C. Outside these
temperatures the device must be completely disconnected from the water.
• Before use, check the whole device, power cord and plug for damage. In case of any damage, the device must
not be used. Please let your dealer assess any damage.
• The device may only be connected if there is a sufficient flow of water.
• To avoid possible harm to eyes or skin, the working of the UV-C lamp should only be checked through the
transparent parts of the device.
• During maintenance, the device and pump must be disconnected from the mains.
Be aware that the device and the lamp can remain hot for up to 10 minutes after being disconnected.
EARTHING THE DEVICE; SEE FIGURE 2
1. Place the strain relief clip (A) about 10-12cm from the eye of the earth cable (B).
2. Slide the eye of the earth cable (B) over the earth pin (C) that is fastened to the housing (D).
3. Slide the first spring washer (E1) over the earth pin (C).
4. Place the hexagonal nut (F) on the earth pin and tighten it.
5. Slide the second spring washer (E2) over the earth pin (C).
6. Slide the strain relief clip (A) over the earth pin (C).
7. Place the last lock nut (G) on the earth pin (C) and tighten it carefully with a spanner #8.
8. Ensure that the sequence follows precisely that shown in figure 2.
4