HQ TB10 Instrucciones página 2

Operation:
1) Insert the power plug into a socket with specification suitable to
this unit.
2) The red waiting indicator will light on the operating panel. After
about 1 minute of pre-heating time, the green operating indicator
will light. Now you may start binding.
3) Choose the thermal cover of the same thickness as of the papers
to be binded. Then place the paper neatly into the thermal cover
and knock it slightly on the table to align the edges of all the paper.
Also make sure that binding side of paper is properly aligned to the
adhesives of the thermal cover.
4) Place the thermal cover into the heating channel. After about 50
seconds, the buzzer will sound again. Now you can remove the
thermal cover from the heating channel. Place the thermal cover
into the cooling channel for 1 minute.
WARNING:
To reduce risk of electric shock, this product should ONLY be
opened by an authorized technician if service is required.
Disconnect the product from mains and other equipment if a
problem should occur. Do not expose the product to water or
moisture.
WARRANTY:
No guarantee or liability can be accepted for any changes and
modifications of the product or damage caused due to incorrect use
of this product.
GENERAL:
Designs and specifications are subject to change without notice.