Technical Data - Blooma Belleterre Manual De Instrucciones

Safety
R
These instructions are for your safety. Please read through
them thoroughly prior to installation and retain them for future
reference.
R
All fittings must be installed by a competent person in
R
accordance with local regulations (IET wiring regulation
BS7671).
R
Check the pack and make sure you have all of the parts listed.
R
R All fittings must be installed by a competent person in
Remove all packaging, wrap etc. from the product.
R
Decide on the appropriate location for your product.
R
CAUTION: IP44 is guaranteed when the product is properly
R
installed and sealed.
R
R
Always avoid the product to be located at corrosive environment.
R
R
Always refer to the installation drawing for the orientation of the
R
product.
R
The product must be securely fixed to the mounting surface
R
using the anchor bolts supplied. The anchor bolts supplied are
R
suitable for masonry or concrete only. Other fixings not supplied
and must be purchased.
R
R The product must be securely fixed to the mounting surface
Take care not to drill into any pipes or mains cables beneath the
surface during mounting holes preparation.
R suitable for masonry or concrete only. Other fixings not supplied
IMPORTANT: The fixing point(s) selected must be capable of
supporting the full weight of the light fitting.
R
R
Wiring diagram is for reference only. Always refer to the terminal
marking for wiring. Ensure that all electrical connections are tight
R IMPORTANT: The fixing point(s) selected must be capable of
and that no loose strands are left out of the terminal block.
R supporting the full weight of the light fitting.
Never put anything on the product or hang anything on any part
R
of this product.
R
Never use the terminal cables to bear the product weight.
R
When the product does not light after installation:
R
> Ensure there is no electricity failure
> Ensure all the connections are secured
R
R
If you have any doubt about installation / use of this product,
R
consult a qualified electrician.
R
Always disconnect the product from mains at least 10 minutes
allowing to cool down before any maintenance or adjustment.
R
R
It is recommended to have a regular schedule of care and
consult a qualified electrician.
maintenance to keep the surface condition well.
R
R
Warranty Period and Conditions
At Blooma, we devote special attention to selecting high-quality materials and use manufacturing techniques that enable us to create
designer and durable product ranges.
That is why we offer a 2-year warranty against product manufacturing defects. This product is under warranty for 2 years as from the date of
purchase, for normal, non-professional household use. The warranty shall only apply upon presentation of the till receipt or the invoice. Keep
your proof of purchase in a safe place.
The warranty covers product breakdowns and malfunctions under the condition that the product is used in accordance with its intended use
and subject to installation and maintenance in accordance with good practice and the information contained in the user's manual.
This product must be installed so that it may be later removed without damaging it.
This contractual warranty does not cover defects and damage caused by the natural wear of parts, bad weather, flooding, heat releases,
freezing, damage caused by water quality (hardness, aggressiveness, corrosion, etc.), by the presence of foreign bodies transported by
water or otherwise (sand, filings, etc.) or the lack of room ventilation, and damages that could be the consequence of improper use, misuse,
negligence, accident or maintenance that is defective or does not comply with good practice or the information in the user's manual.
This contractual warranty does not cover defects and damage caused by the natural wear of parts, bad weather, flooding, heat releases,
The following are also excluded from the warranty: harmful consequences due to the use of accessories and/or non-original equipment
manufacturer or improper replacement parts, disassembly or product modification.
water or otherwise (sand, filings, etc.) or the lack of room ventilation, and damages that could be the consequence of improper use, misuse,
The warranty is limited to those parts recognised as defective. Under no circumstances shall it cover fringe expenses (travel, labour) and
direct and consequential damage.
The following are also excluded from the warranty: harmful consequences due to the use of accessories and/or non-original equipment
Guarantee related queries should be addressed to a store affiliated with the distributor you purchased the product from.
manufacturer or improper replacement parts, disassembly or product modification.
This guarantee is in addition to and does not affect your statutory rights. The warranty is limited to those parts recognised as defective. Under no circumstances shall it cover fringe expenses (travel, labour) and
Guarantee related queries should be addressed to a store affiliated with the distributor you purchased the product from.
3663602895213-3663602895374-Blooma-A5-IM-V02.indb 3

Technical Data

Supply Voltage: 220-240 V~, 50 Hz
1 x Max. 60 W E27 (check bulb dimensions
Bulb Type:
in relation to space available)
This product complies with conformity
1 x Max. 60 W E27 (check bulb dimensions
Conformity with all relevant EC Directive
requirements of the applicable European
requirements.
Regulations or Directives.
This product complies with conformity
Class I product, must be connected to earth.
requirements of the applicable UK Regulations.
IP44
Splash-proof
Class I product, must be connected to earth.
Waste electrical products should not be
disposed of with household waste. Please
IP44
recycle where facilities exist. Check with your
Splash-proof
Local Authority or local store for recycling
Waste electrical products should not be
advice.
disposed of with household waste. Please
xxWyy xx-year; yy-week of the year
recycle where facilities exist. Check with your
Local Authority or local store for recycling
advice.
xxWyy xx-year; yy-week of the year
27/10/2017 2:49 PM