Installing The Blades - Hinkley Lighting INDY FLUSH 901072FMW-NDD Manual Del Usuario

INSTALLING THE BLADES

Screws
Fig. 1
1
2
3
Screw & rubber washer
Blade Arm
Blade
Nut
Place blade over blade arm and align blade with
mounting holes in blade arms. Repeat this procedure
without tightening the screw until all 3 screws and
nuts have been started into the blade arm.
Tighten each screw starting with center screw.
Fasten blade assembly to motor with provided
screws and rubber washers by uses Blade Arm
Wrench. Repeat procedure for remaining blades.
Make sure screws are TIGHT! Loose motor screws
can contribute to unnecessary hum during operation.
NOTE:
Cordless power screwdrivers are NOT recommended,
as they usually strip the heads of the screws and
usually will not fully compress the lock washers on
the motor screws. Use a large flat blade screwdriver
for final tightening to fully compress the washers. This
will help ensure proper alignment of the blades and
noise-free, wobble-free running.
©2021 Hinkley Lighting, Inc. | hinkley.com | 09