Using Your Control(S); Dual Operation Settings; Step-By-Step - Sunbeam 112866 Manual Del Usuario

Using your Control(s):

1 To turn the control ON, simply press the "On/Off" button. The backlit
display light will reset itself by flashing "88" and then will return to
the previous setting and will begin to warm.
CAUTION: ALWAYS turn the warming pillow top mattress pad
control OFF when not in use.
2 To turn the warming mattress pad control OFF simply press the
"On/Off" button.

Step-by-step

1 Lay the warming pillow top mattress pad on the bed with the label at the foot of the bed (pillow top
surface facing up, module facing down).
2 Make sure the control cord is connected into the module at the
bottom of the warming pillow top mattress pad until the plastic
hinges click into place.
CAUTION: Control cord must be COMPLETELY CONNECTED. A risk of
fire could result from a loose connection.
3 Run the control cord on the floor under the bed. Do not sandwich
cord between the mattress and box spring. Avoid any tangling or
pinching.
4 Control Placement:
• Dual Control pillow top warming mattress pad – from the lying position, place primary control
(label on back of control) on the right side of the bed. Place the secondary control on left side of bed.
• Single Control pillow top warming mattress pad – the control can be placed on either
side of the bed.
5 Plug power cord into a 110-120 volt wall outlet.
All manuals and user guides at all-guides.com
Dual control placement:
While lying in bed, each person can have complete control over his/her comfort level for ultimate personalized warmth.
From the lying position – place primary control (label on back of control) on the right side of the bed.
The "secondary"
control operates
the left side.
2
The "primary"
control operates the
right side.
CAUTION: Do not plug main
power cord into the wall outlet
until you have completely set
up your warming product per
the instructions.
• Disconnect power cord from
wall before detaching
control from warming
product.
• Always make sure cords are NOT trapped or pinched
between bed slats, mattress, springs, against wall, foot
board or bed frame, or between furniture, walls
or chairs.
CAUTION: Do not attempt to force the plug. This appliance
has a polarized plug (one blade is wider than the other). To
reduce the risk of electrical shock, this plug is intended to fit
only one way into an outlet. If the plug does not fit in the
outlet, reverse the plug. If it still does not fit, contact a
qualified electrician.
IMPORTANT
9