AVATAR LED
IK08
IP66
PRECAUTIONS:
• Keep the product out of the reach of children.
• Do not immerse this product in water or handle it with wet hands.
• Do not hit the product.
• Do not install the product where there are heat sources or moisture
concentrations.
• Do not handle the product while it is in operation and allow it to cool before
touching it with your hands.
• The product must not be covered with thermal insulation material under
any circumstances.
• Maintain a minimum distance of 1m from the surface or object to be
illuminated.
• If the product is damaged, replace it immediately with a new one.
• Disconnect power before installing the product.
• This product contains components sensitive to static electricity and a
discharge to it could destroy or damage its components.
• Before carrying out any work or maintenance, make sure that the device is
completely disconnected from the power supply.
• The replacement or maintenance of any component must be carried
out with the same elements recommended and supplied by the
manufacturer himself. If this is not the case, any incident on an installation
that has not been carried out in accordance with this instruction sheet is
the responsibility of the installer.
P
Nº LED
WEIGHT
LED
36W
12 LED
30W
40W
20 LED
60W
5 Kg
36W
48W
24 LED
72W
• The light source of this luminaire must be replaced only by the manufacturer,
its technical service or equivalent qualified person.
• The luminaire must be positioned so that a prolonged look is not expected
at the luminaire at a distance closer to 1m.
1/8
525
525
d=1m
525
525
MAXIMUM
MAX. HEIGHT OF
SURFACE WIND
INSTALLATION
EXPOSED
0,151m 2
20
[GRÁFICOS: Unidades en mm/ GRAPHICS: Units in mm/GRAPHIQUES: Unités en mm/GRÁFICOS: Unidades em mm]
NOTE
BEFORE INSTALLING THIS PRODUCT, PLEASE READ THE
INSTRUCTIONS CAREFULLY AND STORE THEM IN A
SAFE PLACE.
THE INSTALLATION SHOULD BE CARRIED OUT BY
TRAINED STAFF.
INCORRECT HANDLING OF THE PARTS OR THE
LIGHT FIXTURE ITSELF MAY IMPAIR THE PROPER
PERFORMANCE OF THIS PRODUCT. IN THIS CASE,
THE MANUFACTURER GUARANTEE SHALL BE DEEMED
VOID.
THE MANUFACTURER GUARANTEE SHALL BE DEEMED
VOID: IF THE INSTALLATION IS NOT PERFORMED IN
ACCORDANCE WITH THE SPANISH LOW VOLTAGE
ELECTROTECHNICAL REGULATION 2002 (REBT 2002).
THE APPLICATION OF IBC BT09-4 OF REBT (INSTALLATION
OF LINE AND LIGHT FIXTURE SURGE PROTECTORS) IS
ESSENTIAL FOR INDUSTRIAL AND PUBLIC LIGHTING
INSTALLATIONS. THE GUARANTEE DOES NOT COVER
AGAINST DAMAGES CAUSED BY SURGES IN LIGHT
FIXTURES WITHOUT SURGE PROTECTORS INSTALLED.
ATTENTION!!!
OBSERVE
PRECAUTIONS
HANDLING
SENSITIVE DEVICES.
septiembre 2018
FOR
ELECTROSTATIC
