Power Connection - Triton Blue TR-3256-200 Manual De Usuario

POWER CONNECTION

INSTALLING A NEUTRIK CONNECTOR ON A POWER CABLE
(fig 1) Put bushing and chuck onto the cable. Prepare cable as shown above. The power cable must is a three-conductor
.
2.5mm cable
2
(fig 2) Insert the wire into the terminals and fasten the clamping device by a flat screw driver.
Push insert and chuck into housing (pay attention to the guiding keyway).
Fasten bushing.
The color-coding schemes and some possible pin identification schemes; if pins are not clearly identified, or if you
have any doubts about proper installation, consult a qualified electrician.
RELAYING POWER TO OTHER DEVICES
(fig 3) The lightings can be linked in a chain by power cables which installed a blue and a light-gray connectors on the
two ends. The light-gray connector connects to the power out socket of the first lighting, and the blue connector
connects to the power in socket of the subsequent lighting, and so on.
The power cable must is a three-conductor 2.5mm
voltage is 110V, Do not connect more than 10 lightings in total to AC
mains power in one interconnected daisy chain. When the voltage
is 230V, Do not connect more than 20 lightings in total to AC mains
power in one interconnected daisy chain.
PHYSICAL INSTALLATION
This lighting can be placed on a horizontal surface such as a stage or clamped to a truss or similar rigging structure in any
orientation using a rigging clamp. When suspending the fixture above ground level, verify that the structure can hold at
least 10 times the weight of all installed devices.
Verify that all external covers and rigging hardware are securely fastened and use an approved means of secondary
attachment such as a safety cable.
12.
cable. When the
2
User manual |TR-3256-200 Triton Blue | August 2021 | www.triton-blue.com
Wire color Conductor
Brown Live
Blue Neutral
Yellow/green Ground
Symbol
L
N