Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
- Remove nuts
- Remove both turn signals.
Preassembly of short license plate holder
- Position license plate holder
base
(included).
- Mount screws
and tighten to 8 Nm.
- Mount both turn signals on license plate holder
- Mount and tighten nuts
Properly route wires and ensure that the wires cannot be
kinked or pinched!
Assembly
- Mount lower rear panel
- Position license plate holder and thread in wire.
- Mount original screws
- Mount original screws
- Join plug-in connector
- Join plug-in connector
- Join plug-in connector
with the washers.
(included) on the license plate
with bushings
and nuts
with the washers.
(included).
and tighten to 12 Nm (Loctite 243).
and tighten to 11 Nm.
for license plate lamp.
for left turn signal.
for right turn signal.
(everything included)
.
7
