Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
3.1.2
INSTALL THE WHEEL
8
1. Insert the wheel assembly (6) into the support rod (8).
2. Align the wheel assembly hole to desired position.
3. Slide bolt (9) through hole and attach fastening knob (10)
to bolt.
The wheel position of the machine is adjustable.You can
control the depth of operation through adjusting the wheel
position.
Wheels can be removed for greater tilling depth.
3.1.3
INSTALL THE TINES
17
16
18
13
The cultivator has four tines —two inner tines stamped B and
C and two outer tines stamped A and D. For correct operation
of the unit, the tines must be installed in the correct
orientation.
1. Put the machine on a flat and smooth surface.
2. Place tine C (16) on the tine shaft (20) to the left of the
gear box. The stamped side of the tine should face away
from the gear box (19).
3. Place tine B (15) on the tine shaft to the right of the gear
box. The stamped side of the tine should face away from
the gear box.
4. Place a felt washer (18) on each side of the tine shaft, and
slide to rest against the inner tines.
9
10
6
NOTE
NOTE
19
15
18
20
English
5. Place the outer tine D (17) on the left side of the tine
shaft. The stamped side should face in toward tine C (16).
6. Place the outer tine A (14) on the right side of the tine
shaft. The stamped side should face in toward tine B (15).
7. To secure the tines to the tine shaft, insert the ring pins
(13) into the holes located on either side of the tine shaft.
The unit will not operate properly if the tines are installed
incorrectly. If you notice a problem with the cultivating
operation of the unit, check for proper tine positioning.
The tines and the machine may damage even if you move
the machine with the motor switched off. To prevent the
tines from touching the ground while moving please tilt the
machine.
3.1.4
INSTALL THE BATTERY PACK
14
13
•
If the battery pack or charger is damaged, replace the
battery pack or the charger.
•
Stop the machine and wait until the engine stops before
you install or remove the battery pack.
•
Read, know, and follow the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack (11) with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.1.5
REMOVE THE BATTERY PACK
1. Push and hold the battery release button (12).
2. Remove the battery pack from the machine.
4
APPLICATIONS
•
Breaking up garden soil to prepare seed bed for planting.
•
Shallow cultivating to remove weeds.
8
NOTE
WARNING
11
12
WARNING
Capítulos
Tabla de contenido
Solución de problemas
