Introduction; Opening The Manual Test Screen - Aethra VX2000 Guida Rapida

Idiomas disponibles

All manuals and user guides at all-guides.com

Quick Guide

1 INTRODUCTION

With the VX2000 option, the D2000Pro is able to perform tests over WAN/datacom

lines with a bit rate up to 2.048 Mbit/s.

Thanks to the possibility to emulate both DTE (Data Terminal Equipment) and DCE

(Data Communications Equipment), the D2000Pro allows to carry out quality tests,

bit error rate (BER), in end-to-end mode over datacom line, or checks toward the

User's DTE (CSU, router, or other WAN equipment).

The criteria monitoring and the possibility to manage local loops (LL), allow to

extend controls over datacom line.

The interfaces supported are: V.35, V.36 and V.11 (X.21),

The following paragraphs refer to various tests available using the D2000Pro

interface, further information about the D2000Pro are available in the User's Manual

of the device.

To select the manual test:

Open the TEST MENU.

The last used setup appears on the screen.

Select the ACCESS field.

Select the type of access, V/X INTERFACE.

Fig. 1-1 (single end)

VX2000

Tabla de Contenido