Granit BT 400 Manual Del Usuario página 6

9. Press <<Enter>> to begin the test.
*Return Feature: Before the test is started, the user can always return to
the previous setting page by pressing <<ENTER>> for 2 seconds.
SURFACE CHARGE NOTICE:
The battery will hold a surface charge if the engine has been running or after
the battery has been charged. The tester may prompt you to remove the
surface charge.
A. Follow the instructions indicating when to turn the headlights on and off or
apply a load into the battery.
IN VEHICLE:
SURFACE CHARGE
IN VEHICLE? YES
OUT OF VEHICLE:
SURFACE CHARGE
IN VEHICLE? NO
B. The tester will resume testing after it detects
that the surface charge is removed.
10. Test the battery for few seconds.
11.
charged or not if tester asks. Press «ENTER» to
confirm choice.
12. When the test is completed, the display shows the actual volts and the actual
HEALTH) and SOC (STATE OF CHARGE)}.
13. One of the six test results will be displayed:
GOOD & PASS
*The battery is good and capable of holding a
charge.
TURN HEADLIGHTS
ON FOR 15 SECS
VOL:
CCA:
IR:
6
TESTING
TESTING
IS BATTERY
CHARGED?
YES/NO
GOOD & PASS
xx.xx V
xxxx CCA/SAE