Tabla de contenido
Idiomas disponibles
Idiomas disponibles
AC Adapter Operation
1. Insert the DC plug (at the end of the adapter cord) into the DC input jack on the
product.
2. Plug the AC adapter into an AC power outlet socket. Only use with the recommended
9V -1.2A AC adapter and make sure the local voltage corresponds to adapter's required
AC input voltage.
MAIN POWER SUPPLY
- Check that the power voltage as shown on the type plate corresponds to your local power
voltage. If it does not, consult your dealer or service organization.
- Connect the AC Adapter to the wall outlet of AC power supply. As soon as you insert the
power plug into the wall outlet, the display time will flash and show
is no battery for backup or battery is weak) Please see below how to set the correct time.
POWER FAILURE
If power failure occurs, the unit will switch off. As soon as the power supply returns,
will flash on the display indicating that you must reset the correct time.
BATTERY BACK-UP SYSTEM
1. Slide the battery cover out.
2. Insert 2 "AAA" batteries into the battery compartment. In the
event of a power failure, the batteries will provide sufficient
power to maintain the time. When AC power is restored, the
correct time will be restored and will not require resetting.
• Neither the display nor the unit will operate until the unit is
connected to an AC outlet.
BATTERY WILL ONLY RESTORE CLOCK SETTINGS WHEN AC POWER IS RESTORED.
• Replace the battery once per year. The service of the battery depends on how often and
for how long the power supply fails. This varies from one region to another.
Note:
1. Always check the time and reset if necessary when first connecting to the AC outlet or
after a power failure.
. The 2 batteries are used for backing up the time in case of AC power failure. When AC power
is not available, do not attempt to operate the unit, otherwise, battery life will be reduced.
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
. The batteries (battery pack or batteries installed) shall not be exposed to excessive heat
such as sunshine, fire or the like.
. Do not attempt to recharge, short-circuit, disassemble, heat or throw the batteries into a fire.
3. Do not mix old and new batteries.
4. Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel cadmium)
batteries.
5. If the device is not to be used for a long period of time, remove the batteries to prevent
damage or injury from possible battery leakage.
6. Do not try to recharge batteries not intended to be recharged; they can overheat and
rupture. (Follow battery maufacturer's directions.)
7. Dispose of batteries properly in accordance with local laws.
IPB0 Eng B.indd 3
All manuals and user guides at all-guides.com
GB - 3
. (Assuming there
00//6 :3:0 PM
Tabla de contenido
