Sage the Steam Zone Guía Rápida página 8

7. Press the START/PAUSE button to start
steaming. RAPID START will flash on the
LCD screen while the steamer heats up.
8. The steaming level (HIGH/LOW) will flash
when steam is being produced. The timer
on the LCD screen will start counting up,
indicating the elapsed cooking time.
9. You can steam up to 45 minutes in this
steaming mode. Press the START/PAUSE
button at any time to stop cooking. After
45 minutes the steamer will beep three
times to indicate steaming is completed.
If KEEP WARM was enabled, the steamer
will automatically enter KEEP WARM mode
for 15 minutes. When KEEP WARM is finished,
the steamer will beep one time.
Combined zone steaming
Use the whole steam zone to cook foods
directly on the steaming tray. With this setting,
the LCD screen will display a single timer.
Split zone steaming
The steaming area can be divided into two
separate zones to cook foods that require different
steaming level and cooking times. The LCD screen
will display two separate timers.
8
Synchronised finish
1. Press the SPLIT ZONE button for split
zone steaming.
2. Press the SYNC FINISH button to enable
synchronised finish mode.
3. Set the steaming level and time for each zone
and proceed as directed for split zone steaming.
4. Press the START/PAUSE button and the
zone with the longer steaming time will start.
The second zone will automatically start so that
both zones finish steaming at the same time.
5. After the steaming time is finished,
the steamer will beep three times. If KEEP
WARM was enabled, the steamer will
automatically enter KEEP WARM mode for
15 minutes. When KEEP WARM is finished,
the steamer will beep one time.
Pause cooking
You can stop/pause steaming in all
steaming modes.
1. During steaming, press the START/PAUSE
button to pause the steaming. The LCD
backlight will change from orange to white.
2. When START is pressed to resume,
RAPID START will flash on LCD for 10 seconds.
Adding water while cooking
1. If the water level gets low during steaming,
the steamer will beep twice and FILL WATER
will flash on the LCD screen.
The steamer and timer will pause and the
LCD backlight will change from orange
to white. The steamer will continue to beep
every 30 seconds until the water is refilled.
2. Pour water into water fill spout.
3. Once the water is refilled, the steamer
will automatically restart.