Helen of Troy HOOT TOOLS PRO SIGNATURE HTDR5581UKE Manual Del Usuario página 4

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
GB
SAVE THESE IMPORTANT SAFETY
INSTRUCTIONS
Please read all instructions before using this appliance.
These instructions are also available on our website.
Please visit www.helenoftroy.com/emea-en/
This appliance is intended for household use only.
WARNING: Do not use this appliance near
bathtubs, showers, basins or other vessels
containing water.
WARNING: When the hairdryer is used in a
bathroom, unplug it after use since the proximity to
water presents a hazard even when the hairdryer is
switched OFF.
For additional protection the installation of a
residual current device (RCD) having a rated
residual operating current not exceeding 30mA
is advisable in the electrical circuit supplying the
bathroom. Ask your installer for advice.
This appliance can be used by children aged from
8 years and above, and by persons with reduced
physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given
supervision or instruction concerning use of the
appliance in a safe way and understand the hazards
involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be made
by children without supervision.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
WARNING: Do not leave the appliance unattended.
Do not allow bare skin or the eyes to come into
contact with any heated surface on the appliance
when in use. Do not place the appliance on any
heat-sensitive surfaces when hot or plugged into
the mains. Always unplug the appliance when not
in use.
4
WARNING: Do not block the air inlet or outlet
during use. When using the appliance, care must
be taken to prevent hair entering the air inlet
opening. The air outlet opening of this appliance
will become hot during use, avoid touching the
outlet or any accessories attached to the outlet.
Note: Use on towel-dried hair only.
WARNING: Should this product malfunction, do
not attempt to repair it. This appliance has no user-
serviceable parts or components.
Styling Tips
• Gently towel-dry hair to remove excess water.
• Set dryer on highest setting and speed and circulate the airflow through your hair. Do
not concentrate airflow on any one area.
• When hair is almost completely dry, lower heat and speed setting and begin to style
hair as desired.
• Use the Concentrator Attachment for a more directed airflow.
• Push the Cool Shot Button to set the style with cool air once you've achieved the
desired style.
• When drying is complete, wait for the appliance to cool before storing. Do not wrap the
cord around the dryer. Use the Hanging Ring. This keeps the cord from tangling and
wearing prematurely.
Cleaning instructions for lint filter(s)
• LINT FILTERS DIFFER FROM DRYER TO DRYER. Some dryers have a filter
inside the Removable End Cap as well as an internal filter inside the air
intake. Others have only an internal lint filter inside the air intake grill.
• CLEAN THE LINT FILTER DAILY. This will extend the life of your dryer and
prevent it from overheating and shutting off.
• Unplug the appliance from the power source. Remove the End Cap by
rotating it counterclockwise until it detaches from the dryer.
• Remove dust and lint from the internal lint filter using a brush, fingers or a
vacuum cleaner.
• Your dryer may also have a lint filter attached to the Removable End Cap.
If it does, clean that filter in the same manner, removing dust and lint from
both the inside and outside of the filter.
• To replace the End Cap, align the End Cap's tabs with the indentations
inside the back grill of the hair dryer. Rotate the End Cap clockwise until it
locks into place.
Overheating Cut-off
This appliance is equipped with a thermostat that will cycle OFF (0) should the heat of the
dryer exceed the optimum drying level, due to partially blocked air inlet or outlet openings.
In the event that the appliance stops, turn the appliance OFF (0) and allow it to cool down.
Once the appliance cools, the thermostat will automatically reset and usage may resume.
5
loading