Initial Settings
Adjusting initial settings
1
Initial settings lets you perform initial setup of
different settings for this unit.
Important
You can use the following functions only when
the remote control is set to DEQ mode.
1 Function display
Shows the function status.
1
Press SOURCE and hold until the unit
turns off.
2
Press o and hold until the clock ap-
pears in the display.
3
Press o to select one of the initial set-
tings.
Press o repeatedly to switch between the
following settings:
ClockDimmer (dimmer)Brightness
(brightness)Digital ATT (digital attenuation)
Telephone (telephone muting/attenuation)
AUX (auxiliary setting)Digital1 (digital
source 1)Digital2 (digital source 2)
Analog1 (analog source 1)Analog2 (ana-
log source 2)Analog3 (analog source 3)
Analog4 (analog source 4)Analog5 (ana-
log source 5)Analog6 (analog source 6)
Audio Reset (audio reset)
# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding
down o until the unit turns off.
All manuals and user guides at all-guides.com
Setting the clock
Use these instructions to set the clock.
1
Press o repeatedly until clock appears in
the display.
2
of the clock display you wish to set.
Pressing m or n will select one segment
of the clock display:
HourMinute
As you select segments of the clock display
the segment selected will blink.
3
Pressing r will increase the selected hour or
minute. Pressing q will decrease the se-
lected hour or minute.
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the cars headlights are turned on. You
can turn the dimmer on or off.
1
Press o repeatedly until Dimmer appears in
the display.
2
Dimmer :ON appears in the display.
# To turn dimmer off, press q.
Press o to select clock.
Press m or n to select the segment
Press q or r to set the clock.
Press o to select Dimmer.
Press r to turn dimmer on.
Section
08
33
En