The initial full charge of the battery may take up to 7 hours, each additional charge will subsequently only require 4-5 hours
to achieve a full charge. Full charge button, charging port and USB port are located under the clear plastic cover on the back.
The light turns on (HIGH, MEDIUM, LOW, FLASHING) and off by pressing the POWER button on the back. The light has a HIGH setting of 1000 lumens, a MEDIUM setting
of 500 lumens, and a LOW setting of 250 lumens and a flashing beacon. The light will automatically reset to the high setting after being turned off. For example: Press
(HIGH setting), press again (MEDIUM setting), press again (LOW setting), press again (FLASHING), press again (OFF) etc.
To gain access to the charge indicator light button, USB power bank port and the micro USB charging port, open the plastic cover located on the back of the light.
Plug in the micro USB cord (included) into the 1A USB wall charger (included). Plug the USB charger into the wall outlet. Plug micro USB cord into the charging port to
charge product. The initial charge can take up to 7 hours; thereafter, a normal charge will take around 4-5 hours for a full charge.
To charge or run an electronic device from the work light, plug the device's USB connector end of the charging cord into the USB power bank port and charge.
To check the battery level of the light, press the battery
charge indicator light. The fixture is equipped with an LED
battery charge level indicator that displays 4 light bars to
indicate a full charge and as the battery charge is depleted,
the indicator lights will progressively diminish until none of
the light bars are lighting.
Good Earth Lighting
- 1 YEAR LIMITED WARRANTY The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period of (1) year from the date of
®
original purchase by the consumer. The fixture is not warrantied for use in a commercial or retail application. The warranty is limited to use in a residential environment. We will repair or replace
(at our option) the unit in the original color and style if available, or in a similar color and style if the original item has been discontinued, without charge. Defective units must be properly packed
and returned to the manufacturer with a letter of explanation and your original purchase receipt showing date of purchase. Call 1-800-291-8838 to obtain a return authorization number and an
address where to ship your defective product. Note: C.O.D. shipments will NOT be accepted. The liability of the manufacturer is in any case limited to replacement of the defective light fixture
product. The manufacturer will not be liable for any other loss, damage, labor costs or injury which is caused by the product. This limitation upon the liability of the manufacturer includes any
loss, damage, labor costs or injury which is (I) to person or property or otherwise; (II) incidental or consequential in nature; (III) based upon theories of warranty, contract, negligence, strict
liability, tort, or otherwise; or (IV) directly, or indirectly related to the sale, use, or repair of the product. This warranty gives you specific rights, and you may also have other rights which vary from
state to state.
FCC Statement:This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures: 1) Reorient or relocate the receiving antenna. 2) Increase the separation between the equipment and receiver. 3) Connect the equipment
into an outlet on a circuit different from that of the receiver. 4) Consult the dealer or an experienced radio/TV technician for help.
Troubleshooting Guide
Problem
Fixture doesn't light.
Fuse blows or circuit
breaker trips when charging.
HIGH
BATTERY LIFE
HIGH (100% Brightness): 2 hours
MEDIUM (50% Brightness): 4 hours
LOW (25% Brightness): 7 hours
BATTERY CHARGING TIME
1A (Micro USB): 4 hours
Before doing any work on the fixture, shut off power supply at the circuit breaker panel
to avoid electrical shock.
Cause
Battery is depleted
Bad charging cord.
Bad charger.
Discontinue use.
MEDIUM
With an adjustable built-in stand, light can be directionally aimed where needed. The stand
is designed to adjust in 45° increments. Folds flat for tight spaces or adjust the stand and
use it as a handle.
Two magnets located on the backof the fixture allow the work light to attach to
any steel or iron surface.
A hole is located in the middle of the handle where the included carabiner clip
can be guided through the hole to hang the light (hook, wire, etc.).
Solution
Charge light.
Replace charging cord.
Discontinue use. Call customer service
at 1-800-291-8838.
Call customer service at 1-800-291-8838.
LOW
FLASHING
SAVE THESE INSTRUCTIONS.
Good Earth Lighting
1400 East Business Center Drive, Ste.
®
108 Mount Prospect, IL 60056
Printed in China
2
