Tabla de contenido
Cordless screwdriver
TECHNICAL SPECIFICATIONS
PRODUCT ELEMENTS
1. On/off switch
2. Bit holder
3. Lamp
4. Switch for changing direction of rotation
5. Knob for locking/adjusting handle
SAFETY
WARNING! Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire
and/or serious injury.
• Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery
pack may create a risk of fire when used with another battery pack.
• Use power tools only with specifically designated battery packs. Use of any other battery packs may create a
risk of injury and fire.
• Avoid damage that can be caused by screws, nails and other elements in your workpiece; remove them before
you start working.
• Always check that the supply voltage is the same as the voltage indicated on the name-plate of the charger
(chargers with a rating of 230V or 240V can also be connected to a 220V supply).
• In case of electrical or mechanical malfunction, immediately switch off the tool or unplug charger from power
source.
• WORLD-PRO TOOLS can assure flawless functioning of the tool only when original accessories are used.
• Use only accessories with an allowable speed matching at least the highest no-load speed of the tool.
• This tool is not a toy, which should not be used by people under the age of 16 years.
• Be careful not to drill or drive into areas where electrical wires may be contacted.
• Ensure that switch is in the middle (locking) position before making any adjustments or changing accessories
as well as when carrying or storing the tool.
• Do not touch the contacts in the charger.
• Do not expose tool/charger/battery to rain.
• Never charge battery outdoors.
• Store tool/charger/battery in locations where temperature will not exceed 40° C or drop below 0° C.
• Batteries will explode in fire, so do not burn battery for any reason.
• When damaged, and under extreme usage and temperature conditions, batteries may start to leak.
- if liquid comes into contact with the skin, wash quickly with soap and water, then with lemon juice or
vinegar.
- if liquid gets into the eyes, flush eyes with clean water for a minimum of 10 minutes and seek immediately
medical attention.
• When battery is not in tool or charger, it should be kept away from metal objects such as nails, screws, keys
etc. to prevent short-circuit
• Do not use charger when damaged; take it to one of the officially registered Service Stations for a safety
check.
• Do not use battery when damaged; it should be replaced immediately.
• Do not disassemble charger or battery.
• Do not attempt to recharge non-rechargeable batteries with the charger.
• Normally when starting to charge the discharged battery, red and green LEDs of the battery charger are on.
When the battery is fully charged only green LED is on. If no LEDs are on while the charger is on, do not use
the battery and the charger and take them to the service center.
• When using your tool continuously, the batteries in your battery pack will become hot. You should let a hot
battery pack cool down for approximately 30 minutes before attempting to recharge.
• In case of long storage, store the battery in fully charged condition. WHEN CONNECTING NEW 3-PIN
3
Tabla de contenido
