GENERAL HANDLING
User Interface Elements
Power to operate the radio is supplied through
the ignition switch, which must be in the ON,
ACC or in ACC Delay mode in order to operate
the radio.
Soft-Keys
Soft-keys are accessible on the touch screen.
Hard-Keys
Hard-keys on the left and right side of the radio
faceplate.
6
All manuals and user guides at all-guides.com
(1) Voice Command (If Equipped)
Press the Voice Command
hard-key (1) and wait for the con-
firmation beep before you say a
voice command.
(2) Uconnect™ Phone (If Equipped)
Press the Uconnect™ Phone
hard-key (2) to either activate the
Uconnect™ system or to cancel an
active phone call.
(3) RADIO
Press the RADIO hard-key (3) to change to a
RADIO mode or to toggle between RADIO
modes.
(4) MEDIA
Press the MEDIA hard-key (4) to change to a
MEDIA mode or to toggle between MEDIA
modes.
(5) ON/OFF VOLUME
It is also possible to set the unit in standby
mode during driving by pressing the ON/OFF
VOLUME rotary knob (5).
NOTE:
If the ignition is switched OFF with the radio
in standby mode, the radio memorizes the
standby state when the ignition is switched
ON again. Press the (5) ON/OFF VOLUME
rotary knob to switch the radio ON. The
radio software is always working when the
ignition is switched ON, even if the radio is
in standby mode. It is still possible to eject
the CD and to display the time if the unit is
switched OFF.
(6) LOAD
To open or close the display, press the LOAD
hard key (6).
After opening the display, it takes a few sec-
onds to eject a CD/DVD, if one was in the slot.
When inserting a disc, make sure the label is
facing up.
The display will close automatically after insert-
ing the disc.
NOTE:
It may take several seconds to recognize the
type of inserted disc (CD, DVD, MP3, etc.).