Hydrofarm autopilot APCTART2 Instrucciones página 3

Q&A
Can I connect more than one device to the unit? Yes, as long as the total amperage of the devices
connected to the unit does not exceed the maximum rating of the unit. We recommend the total
amps not to exceed 75% of the rating.
The timer setting does not seem to be correct? Because of the wide range of timer set-points, any
small adjustment can result in a large change in time setting. If the timer does not seem to be turning
on and off at the correct times, make small adjustments using another timer such as stopwatch or
analog clock as a reference.
What if there is no power? Ensure the unit is getting power. Check the device that is connected to
the unit by plugging it directly into a known power supply. If the unit will not turn on and no LEDs will
illuminate, contact your distributor for repair and warranty issues.
The timer is turning on and off only some of the time, or ALL of the time? Verify that you have
selected the correct timer mode. (DAY Mode versus NIGHT Mode) Depending on what timer mode is
selected, the timer will work when the photocell is activated by the available light level. Ensure enough
light (or darkness) is present to change the status of the photocell from night to day status.
INSTRUCTIONS
SPECIFICATIONS
Input Voltage
Maximum Amperage
On Time Range
Off Time Range
Timing Repeatability
Weight
Dimensions
120V
15A @ 120 VAC
1 second to 60 minutes
1 minute to 14 hours
+/- 3%
<1lb
2.25" x 2.25" x 4.55"
3