Action Air 9452 Instrucciones página 4

TAKE DOWN
Make sure all children exit the product.
Makes sure the product is free from foreign objects.
Turn off the water supply. Detach the water hose from the product. Empty water in the
water hose and dry them in cool place for next time's use.
If the product comes with water bags, like item #9550, please follow the undermentioned
instruction, otherwise, overleap this point. Detach the water bags from the product.
Empty water in the water bags and dry them in cool place for next time's use.
Keep the blower on to dry out the water on the surface of the water slide, then turn over
the water slide to dry out the water at the bottom of the water slide. Make sure the water
slide is 100% dry before turn off the blower.
Turn the blower (air pump) power switch to OFF.
Unplug the blower (air pump) power cord.
Loosen the Velcro and detach the inflation tube from the blower.
The product should deflate on its own within 5 minutes. Make sure the productis entirely
deflated.(refer to picture A)
Remove ground support stakes.
Fold the product in half from both ends, and then fold it in half 2 more times from both
sides, vertically to the first fold. (refer to picture B,C,D)
Roll it up tightly from the end opposite the inflation tube.(refer to picture E,F)
Slip the carry bag over the folded product and stakes (plastic balls or water bags). Zip
the bag. (refer to picture G)
Do not store the product when wet. Store the product and the blower indoors in dry conditions when not in use.
MAINTENANCE
Checks and maintenance of the main parts of the toys should be carried out of regular intervals, if these checks are not carried
out the toys could overturn or otherwise become a hazard. Whenever practical, the instructions shall also be affixed to the toy.
The seasonal inspection and maintenance should be conducted for any damage or leakage of the product.
The product can be wiped clean with a mild detergent. Keep water away from the blower(air pump) at all times.
REPAIR
In case of any breakage of product, please patch up through hand sewing. Each type of product is provided with a repair kit which
includes some pieces of cloth (each color has two pieces) and three 20-meter long threads of different colors. Sewing needles
are not provided and you should purchase by yourself (3# sewing needle is suggested).
Turn off air blower and deflate the product.
Thread a needle with a spare thread and tie a knot at its end.
Close up the broken cloth and sew along the gap. Tie a knot after sewing to avoid loose thread.
In case of cloth breakage (as shown in picture H), please cover the breakage with a piece of patching cloth of proper size. Then sew up
the patching cloth along its sides. While repairing, you should take notice that the sewing should only occur on the surface layer of the
original cloth rather than reaching its underlayer.
In case of breakage in the seam position (as shown in picture I), the sewing should only occur between the two split cloth rather than
reaching the underlayer or any other cloth.
In case of large-size breakage or internal structural damage, please change product or have professionals do the repairing. Air leakage
is normal in the repaired position and air pressure of the repaired product maybe lower than the original. But it will not affect the normal
use of the product.Patching in one position for more than twice is not suggested.
Patching in one position for more than twice is not suggested.
Needles should be taken good care of and not be left on the product after sewing.
It is suggested that persons with sewing technique should do the repairing work.
In case of any confusion about the aforementioned instruction, please contact us at [email protected].
H I
A
B
C
D
4
E
F
G