Maintenance And Care - FINOPOLY 51615 Información Sobre El Uso

8. Operation
8.1. Installation of polishing tools
The left polishing spindle is marked with a groove.
Set the tool on the polishing spindle and screw the
spindle manually tight into the tool. You must screw
the spindle right or left into the polishing tool depen-
ding on the type of spindle (right or left).
For de-mounting it might happen that you have to
use a tool because the polishing tool gets tied up
during operation.
8.2. Polishing
Actuate the main switch. The control light in the
switch lights up. If the switch does not catch check
the power supply.
The speed selector has three positions:
Vertical position unit is in stand-by 0 rpm
Left position low speed 1400 rpm
Right position high speed 2800 rpm
8.3 Removal of polishing spindle
Do never pound on the drive shaft or the poli shing
tools. Thus the bearing could be damaged.
Left polishing spindle
Turn the left de-mounting aid to the right until the
polishing spindle comes off the shaft. Subsequently
tighten the de-mounting aid again.
Right polishing spindle
Turn the right de-mounting aid to the left until the
polishing spindle comes off the shaft. Subsequently
tighten the de-mounting aid again.

9. Maintenance and care

For cleaning and checking of the unit you must
always unplug the unit. The FINOPOLY Polishing
Lathe is maintenance-free. The bearings of the unit
are provided with a long-term lubrication by the
manufacturer. Therefore avoid any lubrication of the
bearings. This could cause damages. It is recom-
mended to clean the varnished housing regularly.
Cleaning agents for metal must not be used. Please
remove chemicals and plaster residues immediately.
From time to time check the condition of the spindles.
The motor has on both sides conically milled shaft
ends with the standard cone 9 mm. These must be
treated gently. Pounding on the shaft ends can
damage the ball bearings and cones.
4
Shaft ends not in use should be covered with an
oil film to prevent corrosion. Before you mount a
polishing spindle or disk-carrier the oil film must be
removed to achieve a good fixation.
Make sure that the power cable is not damaged.
Repairs of the unit should only be done by FINO or an
authorised workshop.
The user has to stand good for damages caused by
unauthorized/arbitrary repairs. The unrestric ted
conditions of delivery and guarantee of FINO apply
for this unit.
10. Storage
Store the FINOPOLY Polishing Lathe in a dry and
clean place.
11. Technical data
Voltage:
Output:
Speed:
Dimensions (L x W x H): 51 x 15 x 22 cm
Height of shaft:
Weight:
12. Availability
FINOPOLY Polishing Lathe
FINOPOLY Polishing Spindle right
FINOPOLY Polishing Spindle left
12.1. Accessories
FINO Polishing Trough
13. Guarantee
Our technical recommendations of application are
based on our own experiences and tests and should
only be regarded as guidelines. It rests with the skills
and experience of the user to verify that the products
supplied by us are suitable for the intended procedu-
res. Our products are undergoing a continuous
further development. We reserve the right of
changes in construction and composition. It is
understood that we guarantee the impeccable
quality of our products.
230 V, 50/60 Hz
400 Watt
1400/2800 rpm
17 cm
11 kg
each 51615
each 51617
each 51618
each 51616