Removing The Transport Protection - ceramill Therm DRS Modo De Empleo

WARNING:
The mains cable may not be damaged!
▷ Do not place objects on the mains cable.
▷ Lay the mains cable in such a manner that
nobody can step on or trip over it.
▷ Pay attention that the cable does not have
contact with hot objects or surfaces.
▷ In case of damage to the insulation: Replace
the mains cable.
▷ Set the mains switch to the 0 position.
▷ Connect the enclosed mains cable to the socket
intended for this purpose on the rear of the fur-
nace.
Fig. 8 Electrical connection
▷ Connect the other end of the cable to the socket
outlet with earthing contact.
The mains cable may only be replaced
against an original mains cable from the
manufacturer.
I N S T A L L A T I O N
5.2.2 Connecting the operating display
CAUTION:
Possible damage to the display!
The top surface of the furnace becomes very hot
during operation.
▷ Never place the display on the furnace.
▷ Connect the USB C cable to the ports on the rear
side of the operating display and the rear side of
the furnace ([6] in figure 2).
5.3

Removing the transport protection

▷ Switch the furnace on via the main switch.
▷ Open the furnace door by pressing button
the display.
▷ Carefully pull off the transport protection from
the sinter base to the front.
Fig. 9 Removing the transport protection
▷ Shut furnace door by pressing button
display.
E N
on
on the
35