Master Plumber 539864-01 Manual Del Usuario página 3

Safety
Important Safety Instructions
SAVE THESE INSTRUCTIONS - This manual contains
important instructions that should be followed during
installation, operation, and maintenance of the product.
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for one of
the following signal words and be alert to the potential
for personal injury!
indicates a hazard which, if not
avoided, will result in death or serious injury.
indicates a hazard which, if not
avoided, could result in death or serious injury.
indicates a hazard which, if not
avoided, could result in minor or moderate injury.
NOTICE addresses practices not related to personal injury.
Carefully read and follow all safety instructions in this
manual and on pump.
Keep safety labels in good condition. Replace missing or
damaged safety labels.
California Proposition 65 Warning
This product and related accessories
contain chemicals known to the State of California to
cause cancer, birth defects or other reproductive harm.
1. Know pump application, limitations, and
potential hazards.
Risk of fire and explosion. Can cause
severe injury, property damage or death. Pump water
only with this pump. Failure to follow this warning can
result in personal injury and/or property damage.
2. Disconnect power before servicing.
3. Release all pressure within system before servicing
any component.
4. Drain all water from system before servicing.
Risk of flooding. Can cause personal
injury and/or property damage. If a flexible discharge
hose is used, pump may move when motor starts. If
it moves so that switch hits side of sump, switch may
stick and prevent pump from starting. Make sure pump
is secured so it cannot move around in sump.
5. Secure discharge line before starting pump. An
unsecured discharge line will whip, possibly causing
personal injury and/or property damage.
6. Check hoses for weak or worn condition before each
use, making certain all connections are secure.
7. Inspect sump, pump and system components
monthly. Keep free of debris and foreign objects.
Perform routine maintenance as required.
Risk of fire. Do not store or rest
objects on or near motor or switch linkage. Keep all
flammable objects or liquids away from motor.
8. Provide means of pressure relief for pumps whose
discharge line can be shut-off or obstructed.
9. Personal Safety:
a. Wear safety glasses when working with pumps.
b. Keep your work area clean, uncluttered and properly
lit – replace all unused tools and equipment.
c. Keep visitors a safe distance from work area.
For parts or assistance, call Master Plumber Pump Customer Service at
d. Make workshop child-proof with padlocks, master
switches, and by removing starter keys.
10. When wiring an electrically driven pump, follow all
electrical and safety codes, as well as most recent
National Electrical Code (NEC) and Occupational
Safety and Health Act (OSHA).
11. This equipment is only for use on 115 volt (single
phase) and is equipped with an approved
3-conductor cord and 3-prong, grounding-type plug.
Risk of electric shock. Can shock,
burn or kill. To reduce risk of electric shock, be
certain that it is connected to properly grounded,
grounding-type receptacle.
Never connect green (or green and
yellow) wire in cord to a live terminal!
Where a 2-prong wall receptacle is encountered, it
must be replaced with properly grounded 3-prong
receptacle installed in accordance with the National
Electrical Code and local codes and ordinances.
12. All wiring should be performed by qualified electrician.
13. Make certain that power source conforms to
requirements of your equipment.
14. Protect electrical cord from sharp objects, hot
surfaces, oil, and chemicals. Avoid kinking cord.
Replace or repair damaged or worn cords immediately.
15. Do not touch an operating motor. Modern motors can
operate at high temperatures.
16. Do not handle pump or pump motor with wet hands
or when standing in water or on damp surface.
Risk of electric shock. Can shock, burn
or kill. If your basement has water or moisture on
floor, do not walk on wet area until all power has been
turned off. If shut-off box is in basement, call electric
company to shut-off service to house, or call local fire
department for instructions. Remove pump and repair
or replace. Failure to follow this warning can result in
fatal electrical shock.
Risk of explosion. Do not ground to a gas
supply line.
Specifications
Power supply required .................................. 115V, 60 Hz
Horsepower (539835, 540163).................................1/3 ...
Motor duty ................................................... Intermittent
Liquid Temp. Range ...................... 32°F to 70°F(0°-21°C)
Individual Branch Circuit
Required GFCI Class A ....................................... 15 Amps
Motor full load (maximum) ................................3.5 Amps
Discharge: Plastic Models .........................1-1/4" FNPT
Cast Iron Models......................1-1/2" FNPT
Performance
GPH (LPH) at Total Feet (M)
HP 5 ft. 10 ft.
(1.52) (3.05)
1/3 3,000 2,460
(11 355L) (9 312L)
3
15 ft. 20 ft.
(4.57) (6.09)
1,620 0
(6 131L) (0L)
800-628-9439