winwel DONA D0815 Manual De Instrucciones

HOME AUTOMATION MODULE D0815
REF. Nº D0815
FAMILY Dona Home
SECURITY INSTRUCTIONS
1. Do not install near heat sources.
2. The module must be installed in a control cabinet (standard
distribution), in DIN rail.
3. Do not remove the module from its module box.
4. If the installation does not follow this instructions, safety and the
normal operation of the system may be compromised.
ENVIRONMENT
Temperature
POWER
Power consumption
Power source
SECURITY
Classification
INPUTS E OUTPUTS
13 digital inputs
2 analog inputs (0 a 10 VDC)
8 relay outputs 230VAC, 16A (Resistive Load)
DIMENSIONS
Rail mounting Din
Weight
Dona . Smart Home
www.dona.life . [email protected]
5 a 40ºC
500mA (max., with all relays on)
12VDC
IP20
l160mm x w90mm x h63mm, 9
modules
≈ 225g
Datasheet
Number
Date
DESCRIPTION
The home automation D0815 module is the device that performs the
commands given to the system and collects information from digital and
analog inputs. This module aims to control external devices such as lighting,
outlets, shutters, watering, sirens, gates.
1. Contacts C, NC and NO
2. Power supply to 12VDC
3. Ethernet port
4. 13 Digital Inputs (2 with impulse reading, I12 and I13)
5. 2 Analog Inputs (0-10VDC)
12VDC Power Supplies: It is recommended to use the MeanWell DR30-12 or
DR60-12 power supplies.
Make sure that the circuit breaker is turned off before starting the
installation. Please read the manual before starting the
installation. For more detailed instructions please visit our website
https://dona.life.
INSTALLATION
- Output devices must use the same type of wiring which would be used in a
conventional electrical installation;
- Inputs - are potential-free contacts or low-voltage devices;
- It is recommended to use Cat5e / 6 cables;
- In the case of analogue sensors, a cable of at least 0.5 mm2 thickness, ideally
with a mesh, must be used. These sensors should not be more than 15 meters
away from the module, if this distance is greater the section of the cable
should be increased;
- The module must be powered using mono or stranded cable.
WARRANTY TERMS AND CONDITIONS
Dona products have a 2 years (24 months) warranty period and the invoice
should be kept for this purpose.
Warranty rights will not apply if the product is damaged by misuse, including
surface damage such as scratches, cuts, rips and changes to the labels
surrounding the product or deformations;
For more information read the eligibility and warranty conditions available on
our website https://dona.life
Praça da Faculdade de Filosofia, N 14, 4710-297 Braga, Portugal
FT-MD08015-003
18-9-2019
Winwel Electronics
T +351 253 268 082 . E [email protected]
www.winwel.com
EN