Idiomas disponibles
Idiomas disponibles
Caution! Read the note of use before using this product
Indoor use only
ENVIRONMENTAL PROTECTION
In accordance with directive 2012/19/EU, when this product arrives at the end of the lifetime, not to throw with the
household refuse. Please bring back it to the manifold centre nearest to on your premise so that it is reprocessed. By
carrying out this gesture, you contribute to the environmental protection.
1 - Technical:
Max Power: 1000W
Voltage: 230V ~ 50Hz
Frequency: 433.32 MHz
Battery: 12V type A23
Maximum range: approx 25m
This product contains no dimmer lighting.
2 - General:
Use only in recessed sockets, do not connect to an extension.
Never follow a number of switches to each other,
Do not connect any apparatus to be monitored (or iron fryer for example), because it could cause a fire to other damage.
Use only indoors, not suitable for outside temperatures between 0 and 35 ° C.
Do not open the device, not entrust repairs to a professional. Incorrect handling or repairs performed poorly may cause electric shock and / or a
short circuit.
Warning: the scope of the remote control is approximately 25m: concrete walls, electronic devices or electromagnetic (neon lamps, telephone
file, headset telephone, television, ...) may strongly influence this value. If possible, remove all devices that may interfere.
3 - How to use:
The buttons A to E on the remote control switches / sockets.
For example, the A button to the left connects the socket A, the A button right off the socket A.
The B button is for the power supply B, etc .... The LED on the remote and the power supply is used to control.
Controlling the switch / socket:
Place the switch / power outlet in any wall outlet. Then connect the device to connect. The instrument should always be connected on. The
remote works only if the power is on.
4 - Setting the system code and program code:
Open the battery compartment on the remote.
The code on the remote system must be set to the desired code using the DIP switches 1 to 5, to prevent disrupting the other remote controls,
even the neighbors. The system codes must be different. For example, if the DIP switches 1,3 and 5 are set to ON, the code is 135, if DIP
switches are located on 2 and 4, the system code is 24.
Unscrew the cover on the back of the switch / outlet. The same system as the remote control should be set in the switch / outlet. Position the
small white buttons 1 to 5 as those of the remote.
Then, the program code must be set by means of small white buttons 6 to 10, to define which button on the remote control each socket. For
example, the button A is a given order; position 6 to ON button and the buttons 7, 8, 9 and 10 to OFF. Do the same for the other taken to each
button on the remote control does only outlet given.
A
This remote control is suitable for 4 sockets in total. Other outlets have the same code system.
ELIMINATION AND RECYCLING OF THE BATTERIES
In order to protect the environment, batteries should not be thrown in the dustbin, incinerated: those contain dangerous substances. After
extraction from the device, it will be necessary bring them back to the nearest recycling center: ask your retailer.
1. Open the plastic lid located at the back of the device.
2. Remove batteries from its site
3. Proceed to the elimination of batteries with the aim of their recycling as indicated previously.
COGEX – AVENUE DE PARIS – 32501 FLEURANCE CEDEX – France
5L
REMOTE CONTROLLED PLUG 10/16A 3 PIECES
REF : 491799
Instruction Manual
B
C
D
491799
E
GB
2/5
