Sears TRACT Manual Del Operador página 8

SAFETY & OPERATION DECALS
This unit has been designed and manufactured to pro-
vide you with the safety and reliability you would expect
from an industry leader in outdoor power equipment
manufacturing.
Although reading this manual and the safety instructions
it contains will provide you with the necessary basic
knowledge to operate this equipment safely and effec-
tively, we have placed several safety labels on the unit to
remind you of this important information while you are
operating your unit.
All DANGER, WARNING, CAUTION and instructional
messages on your rider and mower should be carefully
Decal - Amputation and
Thrown Objects Hazard
Part No. 1704277SM
DANGER
Amputation and
Thrown Objects Hazard
To avoid injury from rotating blades and
thrown debris, stay clear of deck edge
and discharge. Do not mow without
deflector or entire grass catcher in place.
Decal - Operation, Upper
Part No. 7102575YP
To Turn On the Mower Blades:
To Stop the Engine:
1. Sit in seat.
1. Move ground speed levers to
2. Start the engine (see "To Start Engine").
START/PARK.
3. Pull the mower blade switch UP to 2. Move parking brake lever to
turn the mower blades ON.
ENGAGE position.
3. Move engine speed control
to SLOW.
To Drive:
4. Turn ignition switch to OFF.
1. Start the engine (see "To Start Engine").
2. Move parking brake control to
To Turn the Mower Blades Off:
DISENGAGE position.
1. Push the mower blade switch DOWN to
3. Move both ground speed levers in from
turn the mower blades OFF.
PARK position.
4. Move levers as shown to travel.
3
1
Sit in the seat.
2 Move the ground speed levers to START/PARK
positions (move both levers out).
3
Move parking brake control to ENGAGE position.
4 Turn the mower blades OFF (push switch down).
5
Move engine speed control to FAST position
(levers full forward).
6
Pull the choke knob up to CLOSED position.
7
Turn ignition switch to START to crank the engine.
8
After the engine starts:
-release the ignition switch key (it will return to RUN position)
-push the choke knob down to OPEN position
Always set the engine speed to FAST for mowing.
Decal - Operation, Lower
Part No. 7102574YP
Decal - Tracking
Adjustment
Part No.
1726638SM
Decal - Ground
Speed Lever
Part No. 7102576YP
Forward
(Controls Right Drive Wheel)
Neutral Start / Park
Reverse
7102575
5
6
7
4
7102574
7102574
7102578
Decal - Parking Brake
Part No. 7102578YP
1733458
Decal - Cutting Height
Indicator
Part No. 1734335SM
read and obeyed. Personal bodily injury can result when
these instructions are not followed. The information is for
your safety and it is important! The safety decals below
are on your rider and mower.
If any of these decals are lost or damaged, replace them
at once. Contact a Sears Parts & Service Center for
replacements.
These labels are easily applied and will act as a constant
visual reminder to you, and others who may use the
equipment, to follow the safety instructions necessary for
safe, effective operation.
Decal - Control Panel
Part No. 7103214YP
Decal - Cutting
Height Switch
Part No.
1734276SM
RAISE
Right Ground
MOWER
Speed Lever
Cutting
Height
LOWER
MOWER
7102576
1734276
1734276
High Cut
DANGER
4
3
Amputation Hazard
To avoid injury from rotating
blades, stay clear of deck edge.
2
Decal - Amputation Hazard
Part No. 1704276SM
1
Low Cut
8
Decal - Hot Surfaces
Part No. 1734273SM
(Located on RH side)
WARNING
Burn hazard
The exhaust pipe and surrounding
surfaces are hot and can cause
burns.
Avoid contact with hot surfaces.
Decal - Cutting Hazard
Part No. 1734672SM
(Located on rear frame)
Decal - Transmission
Release
Part No. 1734532SM
(Located on rear frame)
Left Ground
Forward
Speed Lever
(Controls Right Drive Wheel)
Start / Park Neutral
Reverse
174xxxx
Decal - Ground Speed Lever
Part No. 1734270SM
1704276