Tabla de contenido
Idiomas disponibles
Idiomas disponibles
◆6.2 STEP BY STEP INSTRUCTIONS
1. Fill in the fuel (see chapter assembly and first putting in operation
2. Clear any foreign objects from the land.
3. Spud the land until the soil is sufficiently loose.
4. Clean the unit thoroughly after every use.
■7. TROUBLES-CAUSES-TROUBLESHOOTING
Trouble
Engine will not
1. Empty tank
start
2. fouled air filter
3. no ignition spark
4. flooded engine
Faltering engine
1. ignition cable detached
2. fuel piping clogged or
3. blocked hole in the fuel
4. water or dirt in fuel
5. fouled air fitter
Engine often
1. too long ignition interval,
switches off when
idling
2. carburetor not set
3. fouled air filter
Drive will not
1. check the drive lever
work properly
2. drive does not work
Excessive
1. loose lock screws
vibrations
Cause
wrong fuel
tank cover
system
defective ignition plug
correctly
cable tension
53
Troubleshooting
1. fill in the tank, check the fuel in
carburetor, defecate the tank and
clean the hole in the lid with a needle
2. clean the air filter
3. clean the ignition plug or use a new
one, check the ignition cable, have the
ignition system checked in a servicing
shop
4. remove the plug, clean and wipe dry,
pull the starting cable several times
with the plug removed
1. push the plug, socket firmly on the
plug
2. clean fuel piping, use fresh/different
fuel replace the fuel tank cover
3. drain the fuel and refuel
4. clean the air filter
1. adjust/replace the ignition plug
2. set up the carburetor
1. adjust the cable tension if necessary
2. have the unit checked in a servicing
shop
1. tighten the lock screws
Tabla de contenido
