Assembly Instructions; Operating Instructions - FAMOSTIL F-POWER 40-240 Manual De Instrucciones

WARNING! Before assembly,
make sure that the tool is
switched off and unplugged.
USING THE DUST COLLECTOR
01
Fit the dust collector on the back of
the tool (PIC 1).
PIC 1
WARNING! Let the tool work at its own pace. Do not overload.
WARNING! Note the voltage, the power socket must match that
REPLACING THE SANDING SHEET
01
To open clamping wire, lift clamping
lever out of it's pocket and then lower
lever off of the base plate. (PIC 2)
02 Place the abrasive sheet between the
clamping wire and base plate (PIC 3).
24

ASSEMBLY INSTRUCTIONS

OPERATING INSTRUCTIONS

shown on the nameplate of the tool.
CLEANING THE DUST COLLECTOR
01 After each use of the sander, it is
essential that it is done cleaning the
filter from dust. To do this, unplug the
box dust filter and open your upper lid.
Take light strikes on a rigid surface, so
that excess of powder will fall off from
the box and filter.
02 Remove the filter from the box by
pushing one of its side locks from the
outside, and with a soft bristles bush,
remove the dust from the filter.
03
After a certain period of use, when the
filter becomes unable to be cleaned or
when any of its parts is damaged, it is
recommended the replacement of the
same.
PIC 2