AWNING
Introduction
To get the most out of your new awning,
please read through these instructions
before use. Please also save the instructions
in case you need to refer to them at a later
date.
Technical data
GB
Fabric:
Frame:
Incline:
Max. wind speed:
623293
623294
629146
629147
629148
629149
629150
629151
Special safety instructions
-
The awning is designed to provide
shade from the sun. It is not suitable as
rain protection.
-
The awning must not be unrolled if the
wind is blowing more than 10 m/s.
-
Always roll the awning up when not in
use.
-
The awning must not be used in
temperatures below zero degrees
Celsius.
-
The awning must not be used if its
mechanical parts are not working
correctly.
-
Make sure that the mounting point can
handle the weight of the awning.
26
280 g/m
polyester
2
Powder-coated
3.5×2.5 m, grey/grey/27 kg
3.5×2.5 m, grey/taupe/27 kg
2.9×2.5 m, white/taupe/20 kg
2.9×2.5 m, white/grey/20 kg
3.5×3 m, white/grey/32.5 kg
3.5×3 m, white/taupe/32.5 kg
4.8×3 m, white/grey/45 kg
4.8×3 m, white/taupe/45 kg
-
Do not hang anything on the awning
frame.
-
Do not place a lit barbecue or other
heat source or naked � ames under the
awning.
-
The awning fabric must be taut when
unrolled.
-
The fabric must not be wet when rolled
up.
-
NB! If you mount the awning anywhere
other than a wall (made of brick,
concrete, porous concrete, etc.), you
0-45°
must buy screws suitable for the
10 m/s
material at the mounting point!
WARNING!
Before the awning opens, all brackets must
be securely mounted to the wall, and all the
bolts must be properly tightened. ALWAYS
CLOSE the awning in stormy weather, windy
weather, rain and when not in use. Failure
to do so can result in material damage and
personal injury. The extension arms are
under high pressure and can cause serious
injury and property damage. Never try to
repair or dismantle them.
Main components
1. End piece
2. Gear housing
3. Arm joint
4. Arm
5. Inner cross bar (square)
6. Roller
7. Fabric
8. Front cross bar
9. Hand crank
10. Bracket
11. Expansion bolts (M10×110)