GAP Supply VQ-LED-600WW Manual De Instalación Del Uso Y Mantenimiento página 5

installation instructions - page 2
5 Once you have all your LED strips cut to
length, attach the 8MM connector to the
ends that will receiver wire. Peel back the
3M adhesive backing prior to inserting the
strip into the connector to ensure a good
connection. Failing to do so could result in
the connector coming loose. (See fig. 5)
NOTE: You only need a connector to connect
from strip to strip or from the strip to the receiver.
You do not need a connector at the end of a run.
6 Measure and cut all of the areas you are
going to install the strip light making sure
to leave enough room for the connector at
the end(s). Make sure that red = (+) and
black = (-). (See fig 6)
NOTE: Make sure throughout the installation
that you keep the polarity (+) 12VDC to (+) and
GND (-) to (-)
7 Measure and cut a piece of the
connection wire so that it is long enough
to go to the next strip. Continue to connect
your LED strips end to end as needed by
stripping back 3/16" of the jacket and
inserting the copper wire into the wire end
of the connector. Tighten the screws
before moving on to the next strip.
(See fig. 7)
fig. 5
fig. 6
fig. 7
8 Once you have the connector
attached properly to the strip with the
polarity matching, peel back and affix
to the clean, dry, dust and oil free
surface. (See fig. 8)
9. Here is how your installation
should look.(See fig. 9)
10. Now you can connect your Power
supply and pair your Q4RF dimmer.
(See pairing Instructions)
fig. 8
Light Strip
Outlet Receiver
Power
Supply
Light Strip Light Strip
Wireless
Dimmer
fig. 9