WAGNER SMART Flow Roller Manual Del Usario página 5

3. Cleanup
Start
Before you begin cleaning:
When cleaning the Smart Flow Roller, make
sure to use the appropriate cleaning solution for
the type of material used.
• If you used latex-based materials, use
warm, soapy water to clean the Smart Flow
Roller.
• If you used oil-based materials, use mineral
spirits.
imPORtant: DO nOt submerge the motor
housing and avoid dripping any cleaning
solution on it!
You will need:
• A large bucket or other container that will
hold cleaning solution.
TIP: A large laundry tub filled with warm,
soapy water is ideal for cleanup if you used
latex-based materials.
Returning excess material to material container
1 2
1. Push the lower part of 2. Press the fill valve onto
the switch to draw any the fill tube. Push upper
remaining material from part of the switch to push
the roller arm back into excess material back into
the main tube. the container.
Cleaning the Smart Flow Roller
1
1. Remove fill tube from the container
lid. Install end of the fill tube into the
valve housing.
4
4. Remove the fill tube. Submerge the
fill valve and roller arm and pull the
plunger in and out a minimum of 5
times.
5
3
3. Remove the spatter
guard. Press locking tab
and remove roller cover
assembly from the roller
arm.
2
2. Flip lever toward MANUAL. This
will allow you to manually slide the
plunger back and forth.
5
5. Remove the roller arm. Submerge
the head of the Smart Flow Roller
and the fill valve and pull the plunger
in and out a minimum of 5 times.
4
4. Remove the roller cap.
Push the roller core out
the other end. Place
spatter guard, cap, core
and cover in a bucket of
the appropriate cleaning
solution.
3
3. Submerge the fill tube into the
appropriate cleaning solution
and pull the plunger in and out a
minimum of 5 times.
6
6. Clean the remaining parts (cap,
core, cover and spatter guard) by
hand using the appropriate cleaning
solution.
English