TUBI T4 Guia Del Usuario página 60

-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Body-worn Operation
This device was tested for typical body-worn operations. To comply With RF
exposure requirements, a minimum separation distance of
maintained between the user's body and the handset, including the antenna.
Third-party belt-clips, holsters, and
belt-clips, holsters, and Similar accessories used by this device should not contain
any metallic components. Body-worn accessories that do not meet these requirements
may not comply with RF exposure requirements and should be avoided.
Specific Absorption Rate (SAR)
This Model wireless phone meets the government's requirements for exposure to
radio waves.
Your mobile device is a radio transmitter and receiver. It is designed and
manufactured to not exceed limits for exposure to radio frequency (RF) energy set by
the Federal Communications Commission (FCC) of the U.S. overnment and by the
Canadian regulatory authorities. These limits are part of comprehensive guidelines
and establish permitted levels of RF energy for the general population. The guidelines
are based on standards that were developed by independent scientific organizations
through periodic and thorough evaluation of scientific studies. The standards include a
substantial safety margin designed for the safety of all persons, regardless of age or
health.
The exposure standard for wireless mobile phones employs a unit of
measurement known as the Specific Absorption Rate, or SAR, The SAR limit set by
the FCC is 1.6 W/Kg.
positions accepted by the FCC with the phone transmitting at its highest certified
power level in all tested frequency bands. Although the SAR is determined at the
highest certified power level, the actual SAR level of the phone while operating can
be well below the maximum value. This is because the phone is designed to operate at
multiple power levels so as to use only the power required to reach the network. In
general, the closer you are to a wireless base station, the lower the power output.
Before a phone model is available for sale to the public in the U.S, it must be tested
and certified to the FCC that it does not exceed the limitestablish for safe exposure.
The tests are performed in positions and locations (e.g, at the ear and worn on the
body) reported to the FCC.
Before a phone model is available for sale to the public in the U.S, it must be
tested and certified to the FCC that it does not exceed the limit establish for safe
exposure. The tests are performed in positions and locations (e.g, at the ear and worn
on the body) reported to the FCC. While there may be differences between the SAR
Similar including the antenna. Third-party
Tests for SAR are conducted using standard operating
60
1.5cm must be