ORILUX THP05NP Manual De Instrucciones página 40

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

Options for protecting devices and cable specification
MODEL
Breaker
Fuse
Power Cord
Signal cable
Note: The above data is adapted to power cord ≤ 10 m .If power cord is >10 m,
wire diameter must be increased. The signal cable can be extended to 50 m
at most.
3. Installation instruction and requirement
The swimming pool heater must be installed by a professional team. The users are
not qualified to install by themselves, otherwise damage may happen to the heater
or threat the body safety of the user.
A. Installation
1) The swimming pool heater should be installed in a place with good ventilation;
2) The frame must be fixed by bolts (M10) to concrete foundation or brackets. The
concrete foundation must be solid and fastened; the bracket must be strong
enough antirust treated;
3) Please don't stack substances that will block air flow near inlet or outlet area, and
there is no barrier within 50cm behind the main machine, or the efficiency of the
heater will be reduced or even stopped;
4) The machine needs an appended pump (Supplied by the user). The recommended
pump specification-flux: refer to Technical Parameter, Max. lift ≥10m;
5) When the machine is running, there will be condensation water discharged from
the bottom, please pay attention to it. Please hold the drainage nozzle (accessory)
39
Rated Current A
Rated Residual Action Current
mA
A
2
(mm
)
2
(mm
)
Above data is subject to modification without notice.
EL 011972
THP05NP
6
30
6
3×1.5
3×0.5
Tabla de contenido
loading

Este manual también es adecuado para:

El 011972

Tabla de contenido