Description Of The System; Setting Up And Operating The System - AL-KO HWA 1001 INOX Manual Del Usuario

Use
Designated use
The domestic water system is designed for home
use in your house or garden. Please observe the
technical data given in the instructions before
putting the system into operation. Your domestic
water system has been designed for use in the
following applications:
−
irrigation and watering, e.g. of your lawn or
flower and vegetable gardens,
−
domestic water supply,
−
increasing pressure in the domestic water
supply.
Please observe the regulations issued by your
local water works. If necessary, ask a plumber.
The system is designed to pump only the follow-
ing liquids:
−
clear water,
−
rain water.
Prohibited use
Your domestic water system is not intended for
permanent operation. The system may not be
used to pump the following liquids:
−
saltwater,
−
beverages or liquid foods,
−
corrosives or chemicals,
−
acids or combustible, explosive or gas-
forming liquids,
−
liquids with a temperature above 35 °C,
−
sandy water or water containing abrasives.

Description of the system

Domestic water system/accessories
(Figs. A to E)
1 pressure switch (hydro-control)
2 electric cable
3 connection cable (pressure switch pump)
4 motor housing
5 pump housing
6 draining screw pump chamber
7 draining screw filter chamber
8 pump inlet/suction hose connection
9 transparent filter cover
10 filler screw
11 pump outlet
12 round seal ring for pump outlet
13 connection nipple
14 flat seal for pressure switch
15 pressure hose connection
16 pressure hose (accessory)
17 pre-filter (accessory)
18 suction fitting (accessory)
Translation of original user instructions
19 seals for filter
20 filter
21 non-return valve
22 seal
23 round seal ring (transparent cover filter
chamber)
24 flat seal
25 LED "Power"
26 LED "Failure"
27 LED "On"
28 "RESET" button
The accessory is not part of the scope of
delivery.
Scope of supply
Your domestic water system comes equipped
with a pressure switch, a pressure gauge and an
electric cable with an earthing-contact type plug.
The hydro-control system and a filter key (see
Fig. D) are part of the scope of supply.
The hydro-control system is an electronic pres-
sure switch with an integrated dry-run protection
and return-flow stop.
Function
The domestic water system works automatically.
The pump automatically switches on or off de-
pending on the pressure set (see technical data).
The system sucks the liquid to be pumped
through the suction hose (8) and lets it out into
the reservoir (11). Upon reaching the set cut-out
pressure (reservoir is full), the system automati-
cally switches off after approx. 15 sec.
Thermal protection
Your domestic water system is equipped with a
thermal protection switch, which switches the
pump off, if it overheats (see Malfunctions).

Setting up and operating the system

Setting up and operating the system
•
Place the device onto a hard, flat surface so
that it cannot tip over and so that it will not be
near the flow of water.
•
Make sure that the device is protected from
rain and any direct exposure to water.
Make sure that electrical plug connectors
are place in an area that is safe from
flooding.
GB 2