LG VR122HW NJM0 El Manual Del Propietario página 35

Problem
Air is not circulating properly.
The air filter is dirty.
The room temperature is too
high.
Cold air is escaping from the
room.
The air conditioner
does not emit cool
The desired temperature
air.
is higher than the set
temperature.
There is a heating source
nearby.
Fan Mode is selected.
Outside temperature is too
high.
The fan speed The Jet Mode, or Auto
cannot be adjusted. Operation Mode is selected.
The temperature The Fan Mode or Jet Mode is
cannot be adjusted. selected.
The air conditioner is suddenly
turned off.
The air conditioner
stops during
operation.
A power failure has occurred
during operation.
Possible Causes Corrective Action
• Make sure that there are no curtains,
blinds, or pieces of furniture blocking
the front of the air conditioner.
• Clean the air filter once every 2 weeks.
• See "Cleaning Air Filter" for more
information.
• In summer, cooling the indoor air fully
may take some time. In this case,
select the Jet Mode to cool the indoor
air quickly.
• Make sure that no cold air is escaping
through the ventilation points in the
room.
• Set the desired temperature to a level
lower than the current temperature.
• Avoid using heat generators like
electric ovens or gas burners while the
air conditioner is in operation.
• During Fan Mode, air blows from
the air conditioner without cooling or
heating the indoor air.
• Switch the operation mode to cooling
operation.
• The cooling effect may not be
sufficient.
• In some operation modes, you
cannot adjust the fan speed. Select
an operation mode in which you can
adjust the fan speed.
• In some operation modes, you cannot
adjust the temperature. Select an
operation mode in which you can
adjust the temperature.
• The Timer Function may have timed
out, which turns the unit off. Check the
timer settings.
• Wait for the power to come back. If
you have the Auto Restart function
enabled, your unit will resume its last
operation several minutes after power
is restored.
EN
35