Tabla de contenido
INSTALLATION - INSTALLATION - INSTALACIÓN
fig. 12
Filter washer
Jointe filtre
Junta-filtro
siNK iNsTAllATiON
Beforeinstallationassembleonthemixerthecomplements:
- screw on the body the threaded stem until the mechanical stop;
- screw on the body the supply hoses paying attention not to damage tightness o-rings;
- screw on the pin inside the body the control rod of the drain orienting it properly;
- screw the knob to the threaded pin on the back of the mixer.
Putthesingle-handmixerontheholeofthesinkandpositiontheshapedgasketandtheflangeonthe
stud
bolt.Tightenupthetierodbyusinga7/16"[11mm]key.
DrAiN DeViCe iNsTAllATiON
Separate the lower pipe from the body of the device and remove the protection plug from the latter.
Install the drain device in the hole of the sink inserting the components in the indicated sequence and
screwing tightly the fastening nut.
Connectthecontrolrodtothelowerpipeofthedrainandthenjoinittothepopuprodofthespoutwith
theclampjoint.
CONNeCTiONs
Carry out the connection of the feeding flexible hoses to the water net interposing the restraint valve
holder with the last one.
ATTENTION! In order to guarantee a long-life product pleae install the garnish with filter supplied with
the equipment and clean them at regular periods. All rithts of warranty are declined in the case the
garnishes are not used and/or the garnishes with filter are misused.
Open the water network and check there are no leakages.
iNsTAllATiON Du lAVABO
red
[16 mm]
[19 mm]
Hot
Blue
5/8"
3/4"
Cold
14
Filter washer
Jointe filtre
Junta-filtro
Tabla de contenido
