GRAFF 5139000 Instrucción De Montaje Y Servicio página 7

Ocultar thumbs Ver también para 5139000:
Instructions for assembly and use • Montage- und Gebrauchsanweisung • Notice technique montage et utilisation • Инcтрукция по монтажу и обслуживанию • Instrucción de Montaje y Servicio • Manuale di Montaggio e Uso
20
11
15
14
10
1
SHOWER ASSEMBLY & RAINSHOWER INSTALLATION
1.
Tighten the connection body brazing (10) nut to the tapped stub on the mixer-tap body (1).
2.
Install the mounting plug (20) on the shower post (11). Slide the shower post (11) on the connection body brazing (10) with care not to damage the o-rings. Align the shower post (11) and fasten with the screw
(14). Install the hole plug (15) (fig. 4.1).
3.
Align the mounting plug (20) with the finished wall surface to keep the two mounting plug holes level. Mark the drilling points through the holes (fig. 4.2).
Carefully undo the shower assembly (10) and (11) from the mixer-tap body. Put it carefully aside in a safe place.
4.
5.
Drill Ø8mm holes at the marked points on the finished wall. Make sure that the hole spacing is as shown in fig. 4.2. Place the rawlplugs (23) in the drilled holes. Fasten the mounting plug (20) to the wall with
the screws (22) and leave a large play on the screws to easily install the shower assembly (10) and (11) (fig. 4.3).
Slide the assembled shower (10) and (11) on the mixer-tap body (1) stub with care not to damage the o-rings. Align the shower assembly. Mind proper location of the rubber gasket (13). Having aligned the
6.
connection body brazing (10), tighten the nut with the adjustable spanners with soft pads on the jaws to prevent damage to the surface finish. Remember to install the decorative cover (19) on the mounting
plug (20) (fig. 4.4). Tighten the screws (22) home.
7.
Slide the decorative cover (19) with the o-ring seal (18) carefully to the installed mounting plug (20). Bring it home with the finished wall. Secure the assembly with the top screw (21). It is very important to
keep the entire assembly vertical.
Tighten the rainshower (12) nut to the shower post (11) arm. Mind proper location of the rubber gaskets (16) and the orifice (17) within the rainshower nut (fig. 4.5).
8.
IOG 5139.00
GB
D
F
RUS
E
IT
THERMOSTATISCHE DUSCHSÄULE• COLONNE DE DOUCHE THERMOSTATIQUE
COLUMNA DE DUCHA TERMOSTÁTICA • COLONNA DOCCIA TERMOSTATICA
20
1
4.1
ТЕРМОСТАТИЧЕCКАЯ ДУШОВАЯ КОЛОННА
40 mm
~40mm
4.2
7
THERMOSTATIC SHOWER COLUMN
23
20
22
1
Rev. 3 December 2017
4.3
GB
loading

Este manual también es adecuado para:

5142800