P.O. Box 342, Delavan, WI 53115
Phone: 1-800-365-6832 • Fax: 1-800-526-3757
2291 0296
Figure 1
2292 0296
Figure 2
T
CHANGE
JAN
FILTER
2293 0296
Figure 3
PRINTED IN U.S.A.
®
The system and installation must comply with all state and local laws and
regulations.
"Do not use with water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after the system."
Min./Max. operating pressure . . .138kPa/862kPa (20 psi/125 psi)
Min./Max. operating temperature . . . .4.5°C/37.7°C (40°F/100°F)
CHANGE
JAN
FILTER
Replacement Filter cartridge (set of 2) . . . . . . . . . . . . .FPWP-TOF
Do not allow filter to freeze; do not expose filter assembly to direct sunlight
(ultra violet light).
Step 1. Remove your faucet aerator.
Step 2. Attach the water filter to your faucet. You may need to use one of
the adapters supplied with the filter. If an adapter is used, be sure to
also use the appropriate washer between the faucet and adapter
(Figure 1).
CHANGE
JAN
FILTER
Step 3. Turn on the cold water and set the selector knob to "FILTERED"
(Figure 2). Flush the filter for 1 or 2 minutes to remove any loose car-
bon. Return the selector knob to "UNFILTERED".
NOTE: Do not run hot water through the filter. Damage may occur
and cause the filter to leak or malfunction.
Step 4. Set the date on the selector knob ahead 3 months (Figure 3). The fil-
ter should be changed after 200 gallons or every 3 months. The filter
life will depend on your individual water conditions and may need
to be changed sooner. If bad taste and odor return it is time to
change the filter.
NOTE: For best results operate the filter in the UNFILTERED position
except when filtered water is needed for drinking, cooking or mak-
ing ice.
For further operating, installation, or maintenance assistance:
Call Flotec Customer Service at 1-800-365-6832
Faucet Attached Water Filter
INSTALLATION INSTRUCTIONS
MODEL FPWF-FA1
(cold water use only)
FP378 (Rev. 10/2/99)