SANUS VuePoint F107b Manual Del Usuario página 5

1 Mount the Wall Plate
Wood stud
1-1
Locate stud
< 16 mm
(5/8 in.)
1-2
Mark the wall
[01]
1-3
Drill pilot holes
1-4
Tighten lag bolts
6902-002026 <00>
All manuals and user guides at all-guides.com
[01]
[01]
[02]
Verify the center of the stud using an awl, a thin nail, or an edge to
edge stud fi nder.
CAUTION:
Avoid potential personal injuries and property
damage!
Any material covering the wall must not exceed 16 mm (5/8 in.).
Minimum wood stud size: common 51 x 102 mm (2 x 4 in.)
(nominal 38 x 89 mm [1½ x 3½ in.]).
Level the wall plate [01] and mark the hole locations.
CAUTION:
Avoid potential injuries or property damage! Pilot
holes MUST be drilled to a depth of 63
mm (7⁄32 in.) diameter drill bit.
63½ mm
(2½ in.)
CAUTION:
Improper use could reduce the holding power of the
lag bolt. To avoid potential injuries or property damage:
DO NOT over-tighten the lag bolts [02].
Tighten the lag bolts [02] only until they are pulled fi rmly against
the wall plate [01].
13 mm 5.5 mm
(1/2 in.) (7/32 in.)
½ mm (2 ½ in.), using a 5.5
5