Keyton FT2 Manual De Instrucciones página 9

operating the chair
Activating a new remote control
Before using a new remote control or a different one:
a) Unplug the chair for 2 minutes.
b) Plug the chair and press ON/OFF on the main control panel of the chair.
c) Once the led of the key ON/OFF of the main control panel is on, press the key ON/OFF of the
remote control. On the screen you will see a drawing of a person as long as there is a connection
between the remote control and the chair.
If there are two or more chairs with remote control, you must never perform simultaneously the process of
ACTIVATING A NEW REMOTE CONTROL. You must finish the process with one chair and then start with the
next one.
On and off functions of the remote control
Press the key ON/OFF of the remote control to turn it on or off.
If the main control panel is not turned off, the remote control will switch off 15 minutes after the last time you
pressed a key.
If the remote control does not work
a) Check the state of the batteries. ATTENTION: USE ONLY ALKALINE BATTERIES (SIZE "AAA"/LR03).
b) The remote control has been designed to work within the armrest area. You should not use it out of
this area.
ON/OFF
This switch turns the chair on and off. If the chair is on, when you press this switch, the automatic
switch-off function will raise the backrest and lower the footrest, stop all the massage systems and
finally turn the chair off. This process can be interrupted at any time by pressing the STOP
button on the control panel.
Stop the massage and the recliners
Press this key to stop all massage functions and to bring the mechanism to the resting position.
Low batteries
If this led blinks, change the batteries in the rear part of the remote control.
9