MIC INPUT - Input socket to connect with your microphone using an XLR or jack cable. Note this amplifier does not provide
phantom power, meaning only dynamic microphones can be used.
MIC LEVEL use this dial to control the volume of the microphone.
GUITAR INPUT - Input socket to connect with your guitar using a 6.5mm jack cable.
BASS use this dial to adjust the low frequency level, with a cut/boost of +/-15dB
MID use this dial to adjust the middle frequency level, with a cut/boost of +/-15dB.
MID FREQ use this dial to adjust the frequency of the mid frequency controlled by MID dial (9). Fully anticlockwise = 200Hz,
fully clockwise = 5KHz.
TREBLE use this dial to adjust the high frequency level, with a cut/boost of +/-15dB
CHORUS SPEED use this dial to adjust the chorus speed of the chorus (vibrations per second).
CHORUS ON/OFF SWITCH this button switches the chorus effect on and off.
CHORUS ON/OFF LAMP this LED lamp illuminates when the chorus has been switched on.
CHORUS DEPTH use this dial to adjust the amount of chorus added to the output sound.
REVERB use this dial to change the amount of reverb added to the overall output. Turning the dial clockwise increases the
decay time, turning anticlockwise
AUX INPUT - Input socket to connect with external media players, such as mp3 players using a 3.5mm jack cable. Note this
input will accept a stereo jack cable.
MASTER VOLUME use this dial to control the overall volume sent to the speaker/headphones.
POWER use this switch to turn the amplifier on and off.
AC POWER INPUT Connect the amplifier to a power source using the provided IEC cable. Heed all safety warnings in this
manual. This amplifier operates at 220-240V, 50/60Hz. Check your local power source before plugging the device in. For more
advice, check the specifications below, or contact the Gear4music customer service team.
FUSE Only ever replace with a like-for-like fuse. For more advice on the fuse used in this amplifier, check the specifications
below, or contact the Gear4music customer service team.
EXTERNAL SPEAKER powered output socket to connect to an additional passive speaker. Before plugging in, check power
and impedance ratings match this amplifier. Do not plug this connection to an additional amplifier.
FOOTSWITCH input socket to connect a single button footswitch. The footswitch can turn on and off the chorus or the reverb
and can be configured using the toggle switch immediately below the input socket.
LINE OUT unamplified output socket to connect to an additional power amplifier or active speaker.
PHONES Output socket to connect to headphones using a 6.5mm jack cable. Note when headphones are connected to the
