Energetics POWER RUN 4.0 Manual De Instrucciones página 7

Ocultar thumbs Ver también para POWER RUN 4.0:
Tabla de contenido
Cleaning
Routine cleaning of your treadmill will extend the product's life.
Warning : To prevent electrical shock, be sure the power to the treadmill is OFF and the power cord
is unplugged from the wall electrical outlet before attempting and cleaning or maintenance.
Important : Never use abrasives or solvents to clean the treadmill. To prevent damage to the
computer, keep liquids away and keep it out of direct sunlight.
After each workout : Wipe off the console and other treadmill surfaces with clean, water dampened
soft cloth to remove excess perspiration.
Weekly : Use of a treadmill mat is recommended for ease of cleaning. Dirt from your shoes contacts
the belt and eventually makes it to underneath the treadmill. Vacuum underneath treadmill once a
week .
Deck Lubrication
The walking belt has been pre-lubricated at the factory. However , it is recommended that the warking board be
checked periodically for lubrication to ensure optimal treadmill performance. Your treadmill should not have to
be lubricated usually within the first year or 500 hours of use.
Every 30 days or 30 hours of operation lift the sides of the walking belt and feel the top surface of the walking
board as far as you can reach. If you signs of silicone, no further lubrication is required. If it feels dry to the
touch, follow the instructions below. Please use a non-petroleum based silicone.
To apply lubricant to the walking belt:
1. Position the walking belt so that the seam is located on top and in center of the walking board.
2. Insert the spray nozzle into the spray head of the lubricant can.
3. While lifting the side of the walking belt, position the spray nozzle between the walking belt and the board
approximately 6 seconds from the front of the treadmill. Apply the silicone spray to the walking board,
moving from the front of treadmill to the rear. Repeat this on the other side of the belt. Spray approximately
4 seconds on each side.
4. Allow the silicone to "set" for 1 minute before using the treadmill.
Spray lubricant from front to back.
7
Tabla de contenido
loading

Tabla de contenido