Cleaning & Maintenance - Igloo IWCTL352CHBKS Instructions Et Recettes

WATER DISPENSER IS NOT HOT
• Make sure cold switch is ON. Switch is located in the back of the water cooler.
• It can take up to 30 minutes after setup to dispense hottest water. Each
time hot water is dispensed, it needs time to heat up again.
•
Make sure back of the dispenser is at least 4 inches from a wall
and that air is free to flow on all four sides of dispenser.
DISPENSER IS NOISY
• Make sure that the dispenser is positioned on a level surface.
CLEANING & MAINTENANCE
General Cleaning
General cleaning should be performed as needed and only takes five minutes or less.
1. Clean the cabinet surfaces using a soft cloth and warm, soapy water. Rinse.
2. Wipe dust in the back of the water cooler to improve efficiency.
3. Remove drip tray cover and hand wash. Take a cloth and warm,
soapy water to rinse the inside of the drip tray. Rinse.
4. Reattach drip tray.
Cleaning Water Lines & Cold Reservoir
Cleaning the water lines and reservoirs is recommended to happen once every three
months. NOTE: Recommended to do before loading a new 3 or 5 gallon jug.
1. Unplug power cord from outlet.
2. Remove water cooler bottle.
3. Remove the plastic water guard and clean with warm, soapy water. Rinse.
4. Fill reservoir with a mixture of water and bleach and let it sit for 30 minutes.
5. Remove cleaning mixture by dispensing it from both taps into a bowl or pitcher.
6. Wipe inside of reservoir with a soft cloth and fill with water.
7. Dispense water from both taps into a bowl or pitcher.
8. Repeat rinsing cycle if chlorine taste persists.
9. Install a new bottle of water and plug in the power cord into grounded outlet.
8