Tabla de contenido
Screw the coupling element (supplied) to the
water connection on the appliance.
Push the water supply hose onto the cou-
pling unit, then connect it to the water supply.
Caution
In case of impurities in the supply water, a 3/4"
fine water filter must be used.
Start up
Caution
Dry runs lasting longer than two minutes lead to
damages to the high pressure pump. If the appli-
ance does not build up pressure within two min-
utes, switch it off and proceed as instructed in
the Chapter "Help with faults".
Connect the high pressure hose to the high
pressure connection of the appliance.
Push the spray lance into the trigger gun and
fasten it by turning it through 90°.
Completely open the water tap.
Insert the mains plug into the socket.
Turn on the appliance "I/ON".
Operation
Danger
The trigger gun is subjected to a recoil force
when the water jet is discharged. Make sure that
you have a firm footing and are also holding the
trigger gun and spray lance firmly.
Unlock the lever on the trigger gun.
Pull on the lever of the trigger gun; the device
will switch on.
Note: Release the lever of the trigger gun; the
device will switch off again. High pressure re-
mains in the system.
Spray lance with 2-way nozzle
Low-pressure flat jet
for low-pressure cleaning or for operation
with detergents
High-pressure flat jet
for large areas of dirt
Select spray type: Release the lever on
the trigger gun and rotate the nozzle head
until the symbol corresponds with the mar-
king on the spray lance. During operation,
this marking must be facing upwards.
Spray lance with Dirtblaster
For particularly dirty items or areas.
Not suitable for use with detergents.
6
English
Working with detergent
Pull detergent suction hose as far as is re-
quired out of the housing.
Suspend end of detergent suction hose in a
container filled with detergent.
Recommended cleaning method
Spray the detergent sparingly on the dry sur-
face and allow it to react, but not to dry.
Spray off loosened dirt with the high-pres-
sure jet.
Interrupting operation
Release the lever on the trigger gun.
Lock the lever on the trigger gun.
During longer breaks (more than 5 minutes),
also turn the appliance off using the "0/OFF"
switch.
Finish operation
After working with detergent, suspend deter-
gent suction hose in a container filled with
clear water, switch the appliance on for
around 1 minute once the spray lance has
been removed and rinse until water runs
clear.
Release the lever on the trigger gun.
Turn off the appliance "0/OFF".
Turn off tap.
Detach the appliance from the water supply.
Press the lever on the trigger gun to release
any remaining pressure in the system.
Lock the lever on the trigger gun.
Pull out the mains plug.
Stow away the mains cable, the high-pres-
sure hose and accessory at the appliance.
Capítulos
Tabla de contenido
