Bremont SUPERMARINE S500 Manual Del Usuario página 4

CHANGING THE STRAP
RemovIng a stRap
Use the end of your watch tool to
carefully lever the spring bar out
of the lug.
FIttIng a stRap
Place one end of the spring bar
into the hole in the lug and use the
end of the watch tool to lever the
other end into position.
SUPERMARINE S500/S2000
AUTOMATIC CHRONOMETER
Your Bremont watch shows you the time in hours, minutes and seconds,
and the day and date (S500/BK/2018 and S501 models show date only).
The mechanical movement with automatic winding has a free-swinging
rotor that keeps the mainspring wound via the motion of your wrist. The
movement in your SUPERMARINE S500/S2000 has 25 jewels, runs at
28,800 bph and has a 38-hour power reserve once fully wound. The S500
is water resistant to 500m (50ATM) and The S2000 is water resistant to
2000m (200ATM). The dial is protected by a dual anti-reflective sapphire
crystal that is retained securely in the case.
To ensure that this rather special watch continues to run beautifully for
years to come you must follow a few important operating instructions...
WINdING THE WATCH
Your watch has a screw-in crown. The purpose of the screw-in crown is
to protect the watch from penetrating water and to avoid unintentional
adjustment of the time or date. To unscrew the crown, rotate the crown to
the left where it will automatically assume position I. This position is also
the winding position for the watch, and you can manually wind the watch by
hand. The movement will automatically start with just a few revolutions of the