DAYRON ALASKA 55W Manual De Instrucciones página 17

1. Open the cardboard box and remove the fan (fig. 1).
2. Mount the bracket plate to the ceiling with two or more screws
3. appropriate anchors and washers. Attention: the supplied screws
for wooden support for concrete ceiling (fig. 2).
4. Insert the support rod through the top cap and bottom cap.
5. Insert the electrical wires coming out of the motor through the su-
pport rod and connect them to the screw terminal located on top
of the support rod.
6. Attach the support rod to the motor using the pin and the pin nut
(fig. 3)
7. Hang the fan on the bracket plate hook and connect the electrical
wire coming from the ceiling to the screw terminal placed on the
top of the support rod, make sure the receiver must be inserted
into the support plate (see Remote control connection).
8. Slide the top cover up and fix it with the screw (fig. 4)
9. Slide down to the bottom cover; it must be supported by the mo-
tor. Fix it with the screw (fig. 4)
10. Center the slots in the blades with the heads of the blade attach-
ment screws and slide the blades so that the head of the screws is
positioned at the end of the slot (fig. 5)
11. Tighten the screw (fig. 6)
12. Remove the screws from the motor connection plate, arrange all
cables carefully on the connection plate.
13. Assemble and align the holes in the back of the LED light with the
three screws on the motor connection plate (fig. 7)
14. Then tighten the three screws on the LED board, connect the con-
nector together with the motor wire, make sure the light kit cannot
move after tightening the screws (fig.8)
WARNING!
Electrical products should not be thrown away with other waste
domestic. Thank you for recycling them at the collection points pro-
vided for this purpose. Contact local authorities or your supplier for
recycling advice. We kindly ask you to recycle the packaging at the
collection points provided for this purpose.