Declaration Of Conformity - KRESS KUC50 Manual De Instrucciones

Operation
Action
Removing The Battery
Inserting The Battery
Selecting The Operating Mode
HAMMER DRILLING
Inserting Drill Bits
Removing Drill Bits
DRILLING & SCREWDRIVING
Inserting Adaptors
Inserting Bits into Chuck
Removing Adaptors
Removing Bits from Chuck
On/Off Switch
Switch Lock
Note: The Switch Trigger Can Be
Locked In The Off Position.
Forward Rotation Control
Reverse Rotation Control
Led Light
Temperature Dependent Overload
Protection
Protection Against Deep
Discharging
WORKING HINTS FOR
YOUR TOOL
If your power tool becomes over heated, set the speed
to maximum and run no load for 2-3 minutes to cool
the motor. SDS-plus tungsten carbide drill bits should
always be used for concrete and masonry.
When drilling in metal, only use HSS drill bits in good
condition. Where possible use a pilot hole before drilling
a large diameter hole.
PROBLEM SOLUTION
1. REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
Charging time problems, having not used a battery
pack for a prolonged time will reduce the battery pack
working time. This can be corrected after several
charge and discharge operations by charging & working
with your tool. Heavy working conditions such as large
screws into hard wood will use up the battery pack
energy faster than lighter working conditions. Do not
re-charge your battery pack below 0
as this will affect performance.
MAINTENANCE
Remove the battery pack from the tool before
Figure
carrying out any adjustment, servicing or
See Fig. A1
maintenance.
Your power tool requires no additional lubrication or
See Fig. A2
maintenance. There are no user serviceable parts in
your power tool. Never use water or chemical cleaners
See Fig. B
to clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls
See Fig. C1
free of dust. Occasionally you may see sparks through
the ventilation slots. This is normal and will not damage
See Fig. C2
your power tool.
See Fig. D1
DECLARATION OF
See Fig. D2
CONFORMITY
See Fig. D3
We,
Positec Germany GmbH
See Fig. D4
Grüner Weg 10, 50825 Cologne, Germany
See Fig. E
Declare that the product
Description Battery-operated Hammer
See Fig. F
Type KUC50 KUC50.2 KUC50.91 (C50
designation of machinery, representative of
hammer)
See Fig. G
Function Hammering various materials
See Fig. H
Complies with the following Directives:
See Fig. I
2006/42/EC
2011/65/EU&(EU)2015/863
2014/30/EU
/
Standards conform to
/
EN 55014-1
EN 55014-2
EN 60745-1
EN 60745-2-6
The person authorized to compile the technical file,
Name Marcel Filz
Address Positec Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
2020/05/25
Allen Ding
Deputy Chief Engineer, Testing & Certification
Positec Technology (China) Co., Ltd
18, Dongwang Road, Suzhou Industrial
Park, Jiangsu 215123, P. R. China
C and above 30 C
o o
11
EN