Tabla de contenido
Idiomas disponibles
Idiomas disponibles
The use of subwoofers leads to a multiple increase in the dynamics of your audio
system. To safeguard your tweeter systems, we recommend protecting these with
an additional protective condenser (100 - 200uF series-connected in front of the
overall mid-tweeter system).
THE FOLLOWING POINTS SHOULD BE HEEDED WHEN CHOOSING
COMPONENTS:
•
Although core coils offer a good price-performance ratio, they also penetrate the
saturation region, which results in acoustic distortions. The coils should therefore
have as little ferrite / iron content as possible.
•
Be sure to adhere to the recommended minimum cable diameter.
•
With regard to condensers, electrolyte condensers with the highest possible
electric strength should be used.
•
The components should not be mounted directly on the speaker. Secure the parts
with screws, cable ties and hot-setting glue. Keep the cable runs as short as
possible.
•
The components are available from specialist electronic equipment dealers.
CABLES TO BE USED
To transport the output from the amplifier to the subwoofer efficiently and reliably,
you should bear in mind when selecting the speaker cable that 2 x 4 mm² gauge
wiring is required for cable lengths in excess of 3 meters. 2 x 2.5 mm² cable is
sufficient for shorter runs. Lay the cable in such a way that short-circuiting cannot
occur, i.e. the cable may at no time be jammed between metal parts. Make sure that
terminals on the speaker are screwed tight and check their contact at regular
intervals.
SUBWOOFER POLARITY
Because of the different spatial conditions prevailing in different vehicles, subwoofer
polarity can best be determined by trial and error. To do this, choose some music
material you know very well and select the setting you like most. Some radios /
control units also offer the possibility of setting the polarity on the appliance itself
(phase). One change in polarity corresponds to a phase shift of 180 degrees.
GB
9
Tabla de contenido
